r5f21346mnfp Renesas Electronics Corporation., r5f21346mnfp Datasheet - Page 681

no-image

r5f21346mnfp

Manufacturer Part Number
r5f21346mnfp
Description
Single-chip Mcus Incorporates The R8c Cpu Core
Manufacturer
Renesas Electronics Corporation.
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
r5f21346mnfp#V0
Manufacturer:
Renesas Electronics America
Quantity:
10 000
R8C/34M Group
R01UH0131EJ0100 Rev.1.00
Jun 21, 2011
Figure 32.8
32.4.11.3 Program Command
The program command is used to write data to the flash memory in 1-byte units.
When 40h is written in the first bus cycle and data is written in the second bus cycle to the write address, auto-
programming (data program and verify operation) starts. Make sure the address value specified in the first bus
cycle is the same address as the write address specified in the second bus cycle.
The FST7 bit in the FST register can be used to confirm whether auto-programming has completed. The FST7
bit is set to 0 during auto-programming and is set to 1 when auto-programming completes.
After auto-programming has completed, the auto-program result can be confirmed by the FST4 bit in the FST
register (refer to 32.4.12 Full Status Check).
Do not write additions to the already programmed addresses.
The program command targeting each block in the program ROM can be disabled using the lock bit.
The following commands are not accepted under the following conditions:
Figure 32.8 shows a Program Flowchart (Flash Ready Status Interrupt Disabled) and Figure 32.9 shows a
Program Flowchart (Flash Ready Status Interrupt Enabled).
In EW1 mode, do not execute this command to any address where a rewrite control program is allocated.
When the RDYSTIE bit in the FMR0 register is set to 1 (flash ready status interrupt enabled), a flash ready
status interrupt can be generated upon completion of auto-programming. The auto-program result can be
confirmed by reading the FST register during the interrupt routine.
Program commands targeting data flash block A when the FMR14 bit in the FMR1 register is set to 1 (rewrite
disabled).
Program commands targeting data flash block B when the FMR15 bit is set to 1 (rewrite disabled).
Program commands targeting data flash block C when the FMR16 bit is set to 1 (rewrite disabled).
Program commands targeting data flash block D when the FMR17 bit is set to 1 (rewrite disabled).
Program Flowchart (Flash Ready Status Interrupt Disabled)
Write the command code 40h
Write data to the write address
Program completed
Full status check
FST7 = 1?
Start
Yes
No
FST7: Bit in FST register
32. Flash Memory
Page 649 of 740

Related parts for r5f21346mnfp