MB88146APFV FUJITSU [Fujitsu Component Limited.], MB88146APFV Datasheet
MB88146APFV
Related parts for MB88146APFV
MB88146APFV Summary of contents
Page 1
FUJITSU SEMICONDUCTOR DATA SHEET Linear IC Converter CMOS D/A Converter for Digital Tuning (12-channel, 8-bit, on-chip OP amp., low-voltage) MB88146A DESCRIPTION The MB88146A is an 8-bit D/A converter with twelve built-in channels. The 12 analog outputs each have a built- ...
Page 2
MB88146A PIN ASSIGNMENT ...
Page 3
PIN DESCRIPTION Pin no. Pin name D/A converter analog output pins ( (Default: output #00 setting level /AO to These pins may be used either as I/O expander ...
Page 4
MB88146A BLOCK DIAGRAM CS SI CLK I/O expander DF D8 8-bit latch R-2R rudder circuit 16-bit shift register and controller DC ...
Page 5
DATA CONFIGURATION 1. Data Configuration MSB (last Setting data 2. Channel Select ...
Page 6
MB88146A 3. Setting Data • Don’t Care/special function (Channel select = “0000” ...
Page 7
I/O Expander [Channel select = “1101”]: Serial Performs parallel conversion of data bits for output on pins D Note that only those pins designated for output in the ESR (expander status register) are output. Shift register ...
Page 8
MB88146A Note: After power turned on, the state of pins and registers is as follows. CC Pin “L” output / /AO Hi-Z state (input state ...
Page 9
ABSOLUTE MAXIMUM RATINGS Parameter Symbol V CC Power supply voltage Input voltage Output voltage 1 V out Input voltage Output voltage 2 V out Power consumption P D ...
Page 10
MB88146A ELECTRICAL CHARACTERISTIC 1. DC Characteristics (1) Digital section Parameter Symbol Pin name Power supply voltage Power supply current Standby current Input leak current I ILK1 “H” level input voltage V ...
Page 11
Operational Amplifier/Analog output section Parameter Symbol Pin name Power supply voltage V CCA Power supply current I CCA Input leak current I ILK2 “H” level digital input V IH2 voltage “L” level digital input V IL2 voltage “H” level ...
Page 12
MB88146A 2. AC Characteristics • For operation 5 Parameter Clock “L” level pulse width Clock “H” level pulse width Clock rise time Clock fall time Serial input setup time Serial input hold time Serial ...
Page 13
Input/Output Timing (CS method) CLK CSU (For input (For output The decision level for CLK, SI, CS, ...
Page 14
MB88146A 3. Analog Output Noise Characteristic Parameter Symbol Digital supply noise P SRD reduction ratio Analog supply noise P SRA reduction ratio D/A supply noise P SRDA reduction ratio Operating noise V N1 I/O expander operating V N2 noise 1 ...
Page 15
Analog Output Noise Description • Output Noise V N1 Noise to analog output during serial data transfer, analog operation, Hi-Z commands. CLK SI Analog operation commands, Hi-Z commands / / ...
Page 16
MB88146A (Continued) • I/O Expander Operation Noise 2 V Noise to analog output during serial for switching between digital output and analog output. CLK SI Serial parallel switching commands, ESR setting commands ...
Page 17
DATA INPUT/OUTPUT TIMING MB88146A Data Input/Output Timing (Serial Bus Format) • D/A converter operation, and I/O expander (serial CLK Data input is enabled at the falling edge of the CS signal. 16-bit ...
Page 18
... In addition recommended that ceramic capacitors or approximately 0 connected as bypass capacitors between the ORDERING INFORMATION Part number MB88146AP MB88146APFV lower than GND voltage, or when voltages are applied to the device VccA GND voltages. Latchup produces a rapid increase in power DD ...
Page 19
PACKAGE DIMENSIONS 24-pin Plastic DIP (DIP-24P-M02) +0.20 30.20 –0.30 INDEX-1 INDEX-2 4.96(.195) MAX 3.00(.118) MIN +0.50 0.98 –0 +.020 .039 –0 1.27(.050) 2.54(.100) MAX 1994 FUJITSU LIMITED D24015S-2C-3 C 24-pin Plastic SSOP (FPT-24P-M03) * 7.75±0.10(.305±.004) INDEX 0.65±0.12(.0256±.0047) 7.15(.281)REF 1994 FUJITSU ...
Page 20
MB88146A FUJITSU LIMITED For further information please contact: Japan FUJITSU LIMITED Corporate Global Business Support Division Electronic Devices KAWASAKI PLANT, 4-1-1, Kamikodanaka Nakahara-ku, Kawasaki-shi Kanagawa 211-8588, Japan Tel: 81(44) 754-3763 Fax: 81(44) 754-3329 http://www.fujitsu.co.jp/ North and South America FUJITSU MICROELECTRONICS, ...