p2008a PulseCore Semiconductor, p2008a Datasheet

no-image

p2008a

Manufacturer Part Number
p2008a
Description
General Purpose Emi Reduction Ic
Manufacturer
PulseCore Semiconductor
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
P2008A
Manufacturer:
ALLIANCE
Quantity:
20 000
XIN/CLKIN
XOUT
November 2006
rev 1.4
Features
Product Description
The P2008A is a versatile spread spectrum frequency
modulator designed specifically for digital camera and
other digital video and imaging applications. The P2008A
reduces electromagnetic interference (EMI) at the clock
source, allowing system wide reduction of EMI of down
stream clock and data dependent signals. The P2008A
allows significant system cost savings by reducing the
Block Diagram
1715 S. Bascom Ave Suite 200, Campbell, CA 95008 • Tel: 408-879-9077 • Fax: 408-879-9018
FCC approved method of EMI attenuation.
Provides up to 15dB of EMI suppression.
Generates a 1X or ½ X low EMI spread
spectrum clock of the input frequency.
Input frequency range: 4MHz to 32MHz.
Internal
components and board space.
Spreading ranges from ±0.8% to ±3.2%.
SSON# control pin for spread spectrum enable
and disable options.
Low Cycle-to-Cycle jitter.
3.3V Operating Voltage.
Ultra-low power CMOS design.
Available in 8-pin SOIC and TSSOP Packages.
Oscillator
Crystal
loop
filter
Notice: The information in this document is subject to change without notice.
Frequenc
Feedbac
minimizes
y
k
PulseCore Semiconductor Corporation
General Purpose EMI Reduction IC
www.pulsecoresemi.com
external
SR0
Modulation
Detector
Phase
SSON#
number of circuit board layers ferrite beads, shielding
and other passive components that are traditionally
required to pass EMI regulations.
The P2008A uses the most efficient and optimized
modulation profile approved by the FCC and is
implemented in a proprietary all digital method.
order to “spread” the bandwidth of a synthesized clock,
and more importantly, decreases the peak amplitudes of
its harmonics. This results in significantly lower system
EMI compared to the typical narrow band signal produced
by oscillators and most frequency generators. Lowering
EMI by increasing a signal’s bandwidth is called ‘spread
spectrum clock generation’.
Applications
The P2008A is targeted towards cable, xDSL, fax
modem, set-top box, USB controller, DSC, and other
embedded systems.
The P2008A modulates the output of a single PLL in
VDD
Loop
Filter
VSS
VCO
PLL
Divider
Output
DIV2
P2008A
ModOUT

Related parts for p2008a

p2008a Summary of contents

Page 1

... FCC and is implemented in a proprietary all digital method. minimizes external The P2008A modulates the output of a single PLL in order to “spread” the bandwidth of a synthesized clock, and more importantly, decreases the peak amplitudes of its harmonics. This results in significantly lower system EMI compared to the typical narrow band signal produced by oscillators and most frequency generators ...

Page 2

... Spreading Range Selection Table.) This pin has an internal pull-up resistor. Power supply for the entire chip 20MHz 24MHz 28MHz ± 1.1% ± 1.0% ± 0.9% ± 1.6% ± 1.4% ± 1.25% 10MHz 12MHz 14MHz ± 1.1% ± 1.0% ± 0.9% ± 1.6% ± 1.4% ± 1.25% P2008A Modulation Rate 32MHz (XIN/CLKIN/20) * 62.5 KHz ± 0.8% ± 0.15% Modulation Rate 16MHz (XIN/CLKIN/20) * 62.5 KHz ± 0.8% ± 0.15 ...

Page 3

... DIV2=1 or leave it unconnected. Selecting the P2008A’s spread options is a matter of either setting SR0=1 or SR0=0. Setting SR0=0 set as a lower modulation spread, while setting introduces a wider spectral spread in the output clock. Refer Modulation output and Spreading Selections Tables ...

Page 4

... General purpose EMI Reduction IC Notice: The information in this document is subject to change without notice. Parameter Min VSS – 0.3 2 10mA 10mA) 2.5 OH 6 Parameter Min DIV2 =0 DIV2 =1 0.7 0.6 P2008A Rating Unit -0.5 to +4.6 V -65 to +125 ° +70 °C 260 °C 150 ° Typ Max Unit - 0 VDD + 0 -35 µA ...

Page 5

... A2 A θ Dimensions Inches Millimeters Min Max Min 0.004 0.010 0.10 0.053 0.069 1.35 0.049 0.059 1.25 0.012 0.020 0.31 0.007 0.010 0.18 0.193 BSC 4.90 BSC 0.154 BSC 3.91 BSC 0.050 BSC 1.27 BSC 0.236 BSC 6.00 BSC 0.016 0.050 0.41 0° 8° 0° P2008A C L Max 0.25 1.75 1.50 0.51 0.25 1.27 8° ...

Page 6

... Notice: The information in this document is subject to change without notice. 8-Pin TSSOP Package θ A1 Dimensions Inches Millimeters Max Min 0.043 0.006 0.05 0.037 0.85 0.012 0.19 0.008 0.09 0.122 2.90 0.177 4.30 0.026 BSC 0.252 BSC 0.028 0.50 0° 8° 0° P2008A Max 1.10 0.15 0.95 0.30 0.20 3.10 4.50 0.65 BSC 6.40 BSC 0.70 8° ...

Page 7

... P2008AF P2008AF-08SR P2008AF P2008AF-08TT P2008AF P2008AF-08TR P2008AF P2008AG-08ST P2008AG P2008AG-08SR P2008AG P2008AG-08TT P2008AG P2008AG-08TR P2008AG Device Ordering Information Licensed under U.S Patent Nos 5,488,627 and 5,631,921 General purpose EMI Reduction IC Notice: The information in this document is subject to change without notice. ...

Page 8

... PulseCore against all claims arising from such use. General purpose EMI Reduction IC Notice: The information in this document is subject to change without notice. P2008A Copyright © PulseCore Semiconductor All Rights Reserved Part Number: P2008A Document Version: v1 ...

Related keywords