cxa1992ar Sony Electronics, cxa1992ar Datasheet - Page 35

no-image

cxa1992ar

Manufacturer Part Number
cxa1992ar
Description
Rf Signal Processing Servo Amplifier
Manufacturer
Sony Electronics
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
CXA1992AR
Manufacturer:
SONY
Quantity:
1 000
Part Number:
CXA1992AR
Manufacturer:
SONY/索尼
Quantity:
20 000
• ATSC
• RDFCT2
• INT
Parallel direct interface
• LOCK (Sled overrun prevention circuit)
When LOCK is not used, Pin 19 (LOCK) should be pulled up to V
The anti-shock function can be controlled by setting D3 with D6 = 1 and D7 = 1.
This function is disabled with D3 = 1 and enabled with D3 = 0.
At this time, SENS1 outputs ATSC.
Even if ATSC is disabled, ATSC is output to SENS1.
When an anti-shock signal is generated during the enable status, TG1 and TG2 switch to GAIN UP mode.
(In the Block Diagram, TG1 is set to the
they switch to GAIN UP mode in conjunction with ATSC.)
When the anti-shock function is not used, Pin 48 (ATSC) should be connected to VC.
DFCT2 can be reset by setting D4 with D6 = 1 and D7 = 1.
DFCT2 is reset with D4 = 1.
After a reset, High is held when DFCT1 rises.
During $1X commands, DFCT2 is output from SENS2.
DFCT2 operates even if DFCT is disabled.
Whether or not DFCT rises at the proper timing for the microcomputer can also be confirmed.
The interruption (scratched disc) countermeasure circuit can be set to operating status by setting D5 with D6
= 1 and D7 = 1.
This circuit is enabled when D5 = 1 and disabled when D5 = 0.
Even if DFCT1 does not rise, this circuit is effective for scratched discs which cause MIRR to rise.
When MIRR rises, the DFCT switch is routed through the low-pass filter.
The interruption countermeasure circuit is forcibly turned OFF regardless of the command when the tracking
gain is increased. (including when the gain is increased by ATSC or LOCK)
Even if DFCT is disabled, the interruption countermeasure circuit operates when INT is enabled.
This circuit operates when LOCK is low.
When LOCK is low, the sled is OFF, and TG1 and TG2 are UP (TRACKING GAIN UP).
TRACKING GAIN
LOCK
SLED
NORMAL
TG1 SW:
TG2 ON
TM2 SW:
SLED ON
side
side
side and TG2 is OFF. Even if TG1 and TG2 are NORMAL mode,
TM2 SW:
SLED OFF
UP
TG1 SW:
TG2 OFF
– 35 –
side
side
CC
with the resistor of approximately 47k .
CXA1992AR

Related parts for cxa1992ar