S29GL032A10BAIR12 SPANSION [SPANSION], S29GL032A10BAIR12 Datasheet - Page 50

• Manufacturer Part Number: S29GL032A10BAIR12
• Description: 64 MEGABIT 32MEGABIT 3.0 BOLT ONLY PAGE MODE FLASH MEMORY
• Manufacturer: SPANSION [SPANSION]

Notes:
1. When Sector Address is specified, any address in the selected sector is acceptable. However, when loading Write-Buffer
2. DQ7 may change simultaneously with DQ5. Therefore, DQ7 should be verified.
3. If this flowchart location was reached because DQ5= “1”, then the device FAILED. If this flowchart location was reached
4. See
48
address locations with data, all addresses must fall within the selected Write-Buffer Page.
because DQ1= “1”, then the Write to Buffer operation was ABORTED. In either case, the proper reset command must be
written before the device can begin another operation. If DQ1=1, write the Write-Buffer-Programming-Abort-Reset
command. if DQ5=1, write the Reset command.
Table 25
and
Table 26
DQ1 = 1?
No
Yes
(Note 1)
for command sequences required for write buffer programming.
(Note 3)
(Note 2)
Yes
Figure 3. Write Buffer Programming Operation
No
Write next address/data pair
Write number of addresses
to program minus 1(WC)
Write first address/data
Write program buffer to
address = Last Loaded
Read DQ7 - DQ0 with
Write “Write to Buffer”
Last Loaded Address
and Sector Address
flash sector address
Read DQ7 - DQ0 at
Buffer Operation?
Sector Address
FAIL or ABORT
command and
S29GLxxxA MirrorBit™ Flash Family
Abort Write to
WC = WC - 1
DQ7 = Data?
DQ7 = Data?
DQ5 = 1?
Address
WC = 0 ?
A d v a n c e
No
Yes
No
No
No
Yes
Yes
Yes
Part of “Write to Buffer”
Command Sequence
I n f o r m a t i o n
Write to buffer ABORTED.
Must write “Write-to-buffer
Abort Reset” command
Write to a different
sequence to return
sector address
to read mode.
PASS
S29GLxxxA_00_A2 January 28, 2005