MC68HC711xxxx Motorola, MC68HC711xxxx Datasheet - Page 238

no-image

MC68HC711xxxx

Manufacturer Part Number
MC68HC711xxxx
Description
Microcontrollers
Manufacturer
Motorola
Datasheet
Application Note
Modifications
Operation
238
This example programmed version 3.4 of the BUFFALO monitor into the
EPROM of an MC68HC711E9; the changes to the BASIC program to
download some other program are minor.
The necessary changes are:
Configure the EVBU for boot mode operation by putting a jumper at J3.
Ensure that the trace command jumper at J7 is not installed because this
would connect the 12-V programming voltage to the OC5 output of the
MCU.
Connect the EVBU to its dc power supply. When it is time to program the
MCU EPROM, turn on the 12-volt programming power supply to the new
circuitry in the wire-wrap area.
Connect the EVBU serial port to the appropriate serial port on the host
system. For the Macintosh, this is the modem port with a modem cable.
For the MS-DOS
through or modem cable. Power up the host system and start the BASIC
program. If the program has not been compiled, this is accomplished
from within the appropriate BASIC compiler or interpreter. Power up the
EVBU.
Answer the prompt for filename with either a [RETURN] to accept the
default shown or by typing in a new filename and pressing [RETURN].
countries.
MS-DOS is a registered trademark of Microsoft Corporation in the United States and other
1.
2. Also in line 30, the starting address of the program is assigned to
3. In line 9570, the start address of the program is stored in the third
4. If any changes are made to the number of bytes in the boot code
assigned to the variable CODESIZE%.
the variable ADRSTART.
and fourth items in that DATA statement in hexadecimal.
in the DATA statements in lines 9500–9580, then the new count
must be set in the variable "BOOTCOUNT" in line 25.
In line 30, the length of the program to be downloaded must be
computer, it is connected to COM1 with a straight
AN1060 — Rev. 1.0
MOTOROLA

Related parts for MC68HC711xxxx