ISL54206A_1010 INTERSIL [Intersil Corporation], ISL54206A_1010 Datasheet - Page 17

• Manufacturer Part Number: ISL54206A_1010
• Description: MP3/USB 2.0 High Speed Switch with Negative Signal Handling
• Manufacturer: INTERSIL [Intersil Corporation]

Revision History
The revision history provided is for informational purposes only and is believed to be accurate, but not warranted. Please go to
web to make sure you have the latest Rev.
09/24/2010
06/15/2010
06/25/2007
10/19/10
DATE
REVISION
FN6515.3
FN6515.2
FN6515.1
FN6515.0
In “USB Switch Cell Off-Isolation” on page 10, changed 2nd sentence of 2nd paragraph from "With a
USB transceiver connected at the D-/D+ pins and with a 32W headphone.." to "With a USB transceiver
connected at the D-/D+ pins and with a 32Ω headphone.."
Added section titled “USB Switch Cell Off-Isolation” to page 10.
On page 1:
Added "The L and R 50kΩ resistors to ground are not shown." to “Application Block Diagram”. Removed
(2) 50kΩ resistors, which were tied to L and R next to "CODEC" block
Updated Pb-free bullet in “Features”
On page 2:
Added PD to “Pin Descriptions” table
Updated Pb-free notes in “Ordering Information” per new verbiage based on lead finish. Added TB347
link to ordering information for reel specifications.
On page 4:
Added Latch up to Abs Max Ratings
Added Theta JC to “Thermal Information”. Changed 10 Ld µTQFN Theta JA from 130 to 145. Changed
10 Ld TDFN Theta JA from 110 to 55. Added applicable Theta JC notes.
Added standard over temp note to common conditions of spec table (Boldface limits apply..)
On page 5:
Changed “ON Leakage Current, I
Room temp MIN/TYP/MAX: from -10/2/10nA to -30/8/30nA
Full temp MIN/MAX: from -75/75nA to -300/300nA
On page 6:
Changed “Positive Supply Current, IDD (Low Power State)” room temp and full temp limits from:
Room temp TYP/MAX: from 1/7nA to 4/25nA
Full temp: removed MAX of 140nA. Added TYP of 150nA
On page 4 to page 6:
Updated standard over-temp Note 15 in MIN/MAX columns of the Electrical Specifications table.
On page 19:
Updated POD L10.2.1X1.6A to most recent revision. Changes were:
Convert to new format by moving dimensions from table onto drawing
Corrected leadframe thickness in Detail x from 0.2 REF to 0.125 REF
Corrected Note 4 to read "...between 0.15mm and 0.30mm...", it previously read "...between .015mm
and 0.30mm..."
Corrected the word "indentifier" in Note 8 to read "identifier".
On page 20:
Updated POD L10.3x3A to most recent revision. Changes were to add Typical Recommended Land
Pattern & convert to new format by moving dimensions from table onto drawing (no dimension
changes)
Initial Release.
17
ISL54206A
Dx
” room temp and full temp limits from:
CHANGE
October 28, 2010
FN6515.3