L6726A_07 STMICROELECTRONICS [STMicroelectronics], L6726A_07 Datasheet - Page 5

• Manufacturer Part Number: L6726A_07
• Description: Single phase PWM controller
• Manufacturer: STMICROELECTRONICS [STMicroelectronics]

L6726A
2
2.1
Pins description and connection diagrams
Figure 3.
Pin descriptions
Table 2. Pins descriptions
Pin n
1
2
3
4
5
6
7
8
LGATE / OC
COMP / DIS
UGATE
PHASE
Pins connection (top view)
Name
BOOT
GND
VCC
FB
LGATE / OC
HS Driver Supply.
Connect through a capacitor (100nF) to the floating node (LS-Drain) pin
and provide necessary bootstrap diode from VCC.
HS Driver Output. Connect to HS mosfet gate.
All internal references, logic and drivers are connected to this pin.
Connect to the PCB ground plane.
LGATE. LS Driver Output. Connect to LS mosfet gate.
OC. Over Current threshold set. During a short period of time following
VCC rising over UVLO threshold, a 10µA current is sourced from this pin.
Connect to GND with an R
Threshold. The resulting voltage at this pin is sampled and held internally
as the OC set point. Maximum programmable OC threshold is 0.55V. A
voltage greater than 0.75V (max) activates an internal clamp and causes
OC threshold to be set at 400 mV. R
default threshold.
Device and LS Driver power supply.
Operative range from 4.1V to 13.2V. Filter with at least 1µF MLCC to GND.
Error Amplifier Inverting Input.
Connect with a resistor R
resistor R
reference.
COMP. Error Amplifier Output. Connect with an R
compensate the device control loop in conjunction to the FB pin.
During the Soft-Start phase, a 10µA current is sourced from this pin so the
compensation capacitors also act to program the SS time.
DIS. The device can be disabled by pulling this pin lower than 0.4V (min).
Setting free the pin, the device enables again.
HS Driver return path, current-reading and adaptive-dead-time monitor.
Connect to the LS drain to sense R
current. This pin is also used by the adaptive-dead-time control circuitry to
monitor when HS mosfet is OFF.
UGATE
BOOT
GND
OS
to GND may be used to regulate voltages higher than the
1
2
3
4
L6726A
Pins description and connection diagrams
FB
OCSET
to the output regulated voltage. Additional
8
7
6
5
Function
resistor greater than 5kΩ to program OC
dsON
OCSET
PHASE
COMP / DIS
FB
VCC
drop to measure the output
not connected sets the 400mV
F
- C
F
// C
P
to GND to
5/24