ATMEGA3290PV ATMEL [ATMEL Corporation], ATMEGA3290PV Datasheet

no-image

ATMEGA3290PV

Manufacturer Part Number
ATMEGA3290PV
Description
8-bit Microcontroller with 32K Bytes In-System Programmable Flash
Manufacturer
ATMEL [ATMEL Corporation]
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
ATMEGA3290PV-10AU
Manufacturer:
SIPEX
Quantity:
17 600
Part Number:
ATMEGA3290PV-10AU
Manufacturer:
Atmel
Quantity:
10 000
Part Number:
ATMEGA3290PV-10AU
Manufacturer:
ATMEL/爱特梅尔
Quantity:
20 000
Part Number:
ATMEGA3290PV-10AUR
Manufacturer:
Atmel
Quantity:
10 000
Features
High Performance, Low Power AVR
Advanced RISC Architecture
Non-volatile Program and Data Memories
JTAG (IEEE std. 1149.1 compliant) Interface
Peripheral Features
Special Microcontroller Features
I/O and Packages
Speed Grade:
Temperature range:
Ultra-Low Power Consumption
– 130 Powerful Instructions – Most Single Clock Cycle Execution
– 32 x 8 General Purpose Working Registers
– Fully Static Operation
– Up to 20 MIPS Throughput at 20 MHz
– On-Chip 2-cycle Multiplier
– In-System Self-Programmable Flash, Endurance: 10,000 Write/Erase Cycles
– Optional Boot Code Section with Independent Lock Bits
– EEPROM, Endurance: 100,000 Write/Erase Cycles
– Internal SRAM
– Programming Lock for Software Security
– Boundary-scan Capabilities According to the JTAG Standard
– Extensive On-chip Debug Support
– Programming of Flash, EEPROM, Fuses, and Lock Bits through the JTAG Interface
– 4 x 25 Segment LCD Driver (ATmega329P)
– 4 x 40 Segment LCD Driver (ATmega3290P)
– Two 8-bit Timer/Counters with Separate Prescaler and Compare Mode
– One 16-bit Timer/Counter with Separate Prescaler, Compare Mode, and Capture
– Real Time Counter with Separate Oscillator
– Four PWM Channels
– 8-channel, 10-bit ADC
– Programmable Serial USART
– Master/Slave SPI Serial Interface
– Universal Serial Interface with Start Condition Detector
– Programmable Watchdog Timer with Separate On-chip Oscillator
– On-chip Analog Comparator
– Interrupt and Wake-up on Pin Change
– Power-on Reset and Programmable Brown-out Detection
– Internal Calibrated Oscillator
– External and Internal Interrupt Sources
– Five Sleep Modes: Idle, ADC Noise Reduction, Power-save, Power-down, and
– 54/69 Programmable I/O Lines
– 64-lead TQFP, 64-pad QFN/MLF, and 100-lead TQFP
– ATmega329PV/ATmega3290PV:
– ATmega329P/3290P:
– -40°C to 85°C Industrial
– Active Mode:
– Power-down Mode:
– Power-save Mode:
Mode
Standby
32K bytes
In-System Programming by On-chip Boot Program
True Read-While-Write Operation
1K bytes
2K bytes
0 - 4 MHz @ 1.8 - 5.5V, 0 - 10 MHz @ 2.7 - 5.5V
0 - 10 MHz @ 2.7 - 5.5V, 0 - 20 MHz @ 4.5 - 5.5V
420 µA at 1 MHz, 1.8V
40 nA at 1.8V
750 nA at 1.8V
®
8-Bit Microcontroller
8-bit
Microcontroller
with 32K Bytes
In-System
Programmable
Flash
ATmega329P/V
ATmega3290P/V
Preliminary
Summary
8021AS–AVR–12/06

Related parts for ATMEGA3290PV

ATMEGA3290PV Summary of contents

Page 1

... Five Sleep Modes: Idle, ADC Noise Reduction, Power-save, Power-down, and Standby • I/O and Packages – 54/69 Programmable I/O Lines – 64-lead TQFP, 64-pad QFN/MLF, and 100-lead TQFP • Speed Grade: – ATmega329PV/ATmega3290PV MHz @ 1.8 - 5.5V MHz @ 2.7 - 5.5V – ATmega329P/3290P MHz @ 2.7 - 5.5V MHz @ 4.5 - 5.5V • Temperature range: – -40°C to 85°C Industrial • ...

Page 2

Pin Configurations Figure 1-1. ATmega329P/3290P 2 Pinout ATmega3290P 1 LCDCAP 2 (RXD/PCINT0) PE0 INDEX CORNER (TXD/PCINT1) PE1 3 4 (XCK/AIN0/PCINT2) PE2 (AIN1/PCINT3) PE3 5 6 (USCK/SCL/PCINT4) PE4 (DI/SDA/PCINT5) PE5 7 8 (DO/PCINT6) PE6 (CLKO/PCINT7) PE7 9 10 VCC GND ...

Page 3

Figure 1-2. Note: 1.1 Disclaimer Typical values contained in this datasheet are based on simulations and characterization of other AVR microcontrollers manufactured on the same process technology. Min and Max values will be available after the device is characterized. 2. ...

Page 4

Block Diagram Figure 2-1. Block Diagram GND VCC DATA REGISTER PORTF AVCC AGND AREF JTAG TAP ON-CHIP DEBUG BOUNDARY- SCAN PROGRAMMING LOGIC USART DATA REGISTER PORTE The AVR core combines a rich instruction set with 32 general purpose working ...

Page 5

The ATmega329P/3290P provides the following features: 32K bytes of In-System Programma- ble Flash with Read-While-Write capabilities, 1K bytes EEPROM, 2K byte SRAM, 54/69 general purpose I/O lines, 32 general purpose working registers, a JTAG interface for Boundary-scan, On-chip Debugging support ...

Page 6

Pin Descriptions The following section describes the I/O-pin special functions. 2.3 Digital supply voltage. 2.3.2 GND Ground. 2.3.3 Port A (PA7..PA0) Port 8-bit bi-directional I/O port with internal pull-up resistors (selected for each bit). ...

Page 7

Port E (PE7..PE0) Port 8-bit bi-directional I/O port with internal pull-up resistors (selected for each bit). The Port E output buffers have symmetrical drive characteristics with both high sink and source capability. As inputs, Port E ...

Page 8

RESET Reset input. A low level on this pin for longer than the minimum pulse length will generate a reset, even if the clock is not running. The minimum pulse length is given in Characteristics” on page 2.3.13 XTAL1 ...

Page 9

... Resources A comprehensive set of development tools, application notes and datasheets are available for download on http://www.atmel.com/avr. 8021AS–AVR–12/06 ATmega329P/3290P 9 ...

Page 10

About Code Examples This documentation contains simple code examples that briefly show how to use various parts of the device. These code examples assume that the part specific header file is included before compilation. Be aware that not all ...

Page 11

Register Summary Note: Address Name Bit 7 LCDDR19 SEG339 (0xFF) LCDDR18 SEG331 (0xFE) LCDDR17 SEG323 (0xFD) LCDDR16 SEG315 (0xFC) LCDDR15 SEG307 (0xFB) LCDDR14 SEG239 (0xFA) LCDDR13 SEG231 (0xF9) LCDDR12 SEG223 (0xF8) LCDDR11 SEG215 (0xF7) LCDDR10 SEG207 (0xF6) LCDDR09 SEG139 ...

Page 12

Address Name Bit 7 UBRR0L (0xC4) Reserved - (0xC3) UCSR0C - (0xC2) UCSR0B RXCIE0 (0xC1) UCSR0A RXC0 (0xC0) Reserved - (0xBF) Reserved - (0xBE) Reserved - (0xBD) Reserved - (0xBC) Reserved - (0xBB) USIDR (0xBA) USISR USISIF (0xB9) USICR USISIE ...

Page 13

Address Name Bit 7 TCNT1H (0x85) TCNT1L (0x84) Reserved - (0x83) TCCR1C FOC1A (0x82) TCCR1B ICNC1 (0x81) TCCR1A COM1A1 (0x80) DIDR1 - (0x7F) DIDR0 ADC7D (0x7E) Reserved - (0x7D) ADMUX REFS1 (0x7C) ADCSRB - (0x7B) ADCSRA ADEN (0x7A) ADCH (0x79) ...

Page 14

Address Name Bit 7 TCNT0 0x26 (0x46) Reserved - 0x25 (0x45) TCCR0A FOC0A 0x24 (0x44) GTCCR TSM 0x23 (0x43) EEARH - 0x22 (0x42) EEARL 0x21 (0x41) EEDR 0x20 (0x40) EECR - 0x1F (0x3F) GPIOR0 0x1E (0x3E) EIMSK PCIE3 0x1D (0x3D) ...

Page 15

Instruction Set Summary Mnemonics Operands ARITHMETIC AND LOGIC INSTRUCTIONS ADD Rd, Rr Add two Registers ADC Rd, Rr Add with Carry two Registers ADIW Rdl,K Add Immediate to Word SUB Rd, Rr Subtract two Registers SUBI Rd, K Subtract ...

Page 16

Mnemonics Operands BRVC k Branch if Overflow Flag is Cleared BRIE k Branch if Interrupt Enabled BRID k Branch if Interrupt Disabled BIT AND BIT-TEST INSTRUCTIONS SBI P,b Set Bit in I/O Register CBI P,b Clear Bit in I/O Register ...

Page 17

Mnemonics Operands PUSH Rr Push Register on Stack POP Rd Pop Register from Stack MCU CONTROL INSTRUCTIONS NOP No Operation SLEEP Sleep WDR Watchdog Reset BREAK Break 8021AS–AVR–12/06 Description STACK ← ← STACK (see specific descr. for Sleep ...

Page 18

Ordering Information 7.1 ATmega329P (3) Speed (MHz) Power Supply 10 1.8 - 5.5V 20 2.7 - 5.5V Notes: 1. This device can also be supplied in wafer form. Please contact your local Atmel sales office for detailed ordering information ...

Page 19

... For Speed vs. V see Figure 26-1 on page 330 CC 100A 100-lead 1.0 mm, 0.5 mm Lead Pitch, Thin Profile Plastic Quad Flat Package (TQFP) 8021AS–AVR–12/06 (2) Ordering Code Package Type ATmega3290PV-10AU ATmega3290P-20AU and Figure 26-2 on page 330. Package Type ATmega329P/3290P (1) Operational Range Industrial 100A 0° ...

Page 20

Packaging Information 8.1 64A PIN 0˚~7˚ L Notes: 1. This package conforms to JEDEC reference MS-026, Variation AEB. 2. Dimensions D1 and E1 do not include mold protrusion. Allowable protrusion is 0.25 mm per side. Dimensions ...

Page 21

Marked Pin TOP VIEW BOTTOM VIEW Note: 1. JEDEC Standard MO-220, (SAW Singulation) Fig. 1, VMMD. 2. Dimension and tolerance conform to ASMEY14.5M-1994. 2325 Orchard Parkway San Jose, CA 95131 R ...

Page 22

PIN 0˚~7˚ L Notes: 1. This package conforms to JEDEC reference MS-026, Variation AED. 2. Dimensions D1 and E1 do not include mold protrusion. Allowable protrusion is 0.25 mm per side. Dimensions D1 and E1 ...

Page 23

Errata 9.1 ATmega329P rev. A • Interrupts may be lost when writing the timer registers in the asynchronous timer 1. Interrupts may be lost when writing the timer registers in the asynchronous timer If one of the timer registers ...

Page 24

Datasheet Revision History Please note that the referring page numbers in this section are referring to this document.The referring revision in this section are referring to the document revision. 10.1 Rev.8021A – 12/06 1. Initial version. ATmega329P/3290P 24 8021AS–AVR–12/06 ...

Page 25

Atmel Corporation 2325 Orchard Parkway San Jose, CA 95131, USA Tel: 1(408) 441-0311 Fax: 1(408) 487-2600 Regional Headquarters Europe Atmel Sarl Route des Arsenaux 41 Case Postale 80 CH-1705 Fribourg Switzerland Tel: (41) 26-426-5555 Fax: (41) 26-426-5500 Asia Room 1219 ...

Related keywords