M30622SAFP MITSUBISHI [Mitsubishi Electric Semiconductor], M30622SAFP Datasheet - Page 272

• Manufacturer Part Number: M30622SAFP
• Description: SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
• Manufacturer: MITSUBISHI [Mitsubishi Electric Semiconductor]

272
Revision History
REV.A1
REV. A2
Version
Revision history
Page 145 Note 2
Page 115, 139, Bit 3 of the UART2 special mode register 2 (bit symbol)
Page 43, Figure 1.10.6
Page 144, Figure 1.16.32, bit 5 of the SI/Oi control register (i=3, 4)
Page 144, Figure 1.16.32, Note 2
• Before data can be written to the SI/Oi transmit/receive register (addresses
0360
the SI/Oi Control Register (addresses 0362
set bit), make sure the CLKi pin input is held low. ---> • Before data can be written
to the SI/Oi transmit/receive register (addresses 0360
input must be in the high state. Also, before rewriting the SI/Oi Control Register
(addresses 0362
pin input is held high.
ASL --> ALS
Note: Writing a value to an address after “1” is written to this bit returns the bit to
Transfer direction lect bit --->Transfer direction select bit
When using the port as an input/output port by setting the SI/Oi port select bit (i =
3, 4) to “1”, be sure to set the sync clock select bit to “1”.
--->
When using the port as an input/output port by setting the SI/Oi port select bit (i =
3, 4) to “0”, be sure to set the sync clock select bit to “1”.
16
“0” . Other bits do not automatically return to “0” and they must therefore
be reset by the program.
, 0364
16
), the CLKi pin input must be in the low state. Also, before rewriting
16
, 0366
16
M16C/62A Group data sheet
)’s bit 7 (S
Contents for change
OUTi
initial value set bit), make sure the CLKi
16
, 0366
16
)’s bit 7 (S
16
, 0364
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
16
OUTi
), the CLKi pin
initial value
M16C / 62A Group
Mitsubishi microcomputers
Revision
99.12.21
00.7.10
00.7.3
date