MJE13003-P UTC [Unisonic Technologies], MJE13003-P Datasheet
MJE13003-P
Related parts for MJE13003-P
MJE13003-P Summary of contents
Page 1
... UNISONIC TECHNOLOGIES CO., LTD MJE13003-P NPN SILICON POWER TRANSISTOR DESCRIPTION These devices are designed high-speed power switching inductive circuits where fall time is critical. They are particularly suited for 115 and 220V applications in switch mode. FEATURES * Reverse biased SOA with inductive load @ Tc=100°C * Inductive switching matrix 0.5 ~ 1.5 Amp, 25 and 100° ...
Page 2
... MJE13003-P ABSOLUTE MAXIMUM RATINGS PARAMETER Collector-Emitter Voltage Collector-Base Voltage Emitter Base Voltage Collector Current Base Current Emitter Current Total Power Dissipation (T =25°C) C Junction Temperature Storage Temperature Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged. ...
Page 3
... MJE13003-P ELECTRICAL CHARACTERISTICS PARAMETER OFF CHARACTERISTICS (Note) Collector-Emitter Sustaining Voltage Collector Cutoff Current Emitter Cutoff Current SECOND BREAKDOWN Second Breakdown Collector Current with bass forward biased Clamped Inductive SOA with base reverse biased ON CHARACTERISTICS (Note) DC Current Gain Collector-Emitter Saturation Voltage Base-Emitter Saturation Voltage ...
Page 4
... MJE13003-P APPLICATION INFORMATION Table 1.Test Conditions for Dynamic Performance Reverse Bias Safe Operating Area and Inductive Switching Coil Data : V =20V CC Ferroxcube core #6656 Vclamp=300V Full Bobbin ( ~ 200 Turns) #20 Table 2. Typical Inductive Switching Performance (°C) (µs) (A) (µs) 1.3 0.23 25 0.5 1.6 0.26 100 25 1.5 0.10 1 100 1 ...
Page 5
... MJE13003-P SWITCHING TIMES NOTE In resistive switching circuits, rise, fall, and storage times have been defined and apply to both current and voltage waveforms since they are in phase. However, for inductive loads, which are common to switch mode power supplies and hammer drivers, current and voltage waveforms are not in phase. Therefore, separate measurements must be made on each waveform to determine the total switching time ...
Page 6
... MJE13003-P SAFE OPERATING AREA INFORMATION FORWARD BIAS There are two limitations on the power handling ability of a transistor: average junction temperature and second breakdown. Safe operating area curves indicate I operation; i.e., the transistor must not be subjected to greater dissipation than the curves indicate. The data of Fig.5 is based on T ...
Page 7
... MJE13003-P TYPICAL CHARACTERISTICS DC Current Gain =150℃ 25℃ -55℃ = = 0.02 0.03 0.05 0.07 0.1 0.2 0.3 Collector Current,I C Base-Emitter Voltage 1.4 V BE(SAT BE(ON) 1 =-55℃ J 25℃ 0.8 25℃ 0.6 150℃ 0.4 0.03 0.05 0.07 0.1 0.2 0.3 0.02 Collector Current,I C Collector cut-off Region =250V =150℃ ...
Page 8
... MJE13003-P TYPICAL CHARACTERISTICS(Cont.) 100 100 Ta (°C) UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein ...