CB017E0102JBA

Manufacturer Part NumberCB017E0102JBA
DescriptionFilm Chip 1,0 nF 100 V 5 %
ManufacturerAVX Corporation
CB017E0102JBA datasheet
 


Specifications of CB017E0102JBA

Lead_time154Pack_quantity3900
1
Page 1
2
Page 2
3
Page 3
4
Page 4
5
Page 5
6
Page 6
7
Page 7
8
Page 8
9
Page 9
10
Page 10
11
12
13
14
15
16
17
18
19
Page 1/19

Download datasheet (207Kb)Embed
Next
Film Chip Capacitors
PEN DIELECTRIC – CB Series
APPLICATIONS
General purpose function in low voltage applications where
miniaturization and SMD is required. Typical applications
would be:
• Automotive (Airbag, Fuel injection calculator...)
• Telecom (Public switching systems, modems, telephone
set, cordless, mobile)
• Industrial (SMPS, Power convertor module...)
PERFORMANCE CHARACTERISTICS
Climatic Category
Capacitance Range
Tolerance on C
R
Nominal Voltages
Test Voltage
Soldering methods
Tangent of Loss Angle at 1kHz (DF)
Insulation resistance minimum : IR
Temperature range
20
GENERAL DESCRIPTION
Film chip capacitor using a naked and stacked construction with
metallized PEN (polyethylene naphtalate).
ADVANTAGES
• Use of high temperature dielectric films make these
capacitors suitable for IR or vapor phase reflow processes.
This chip is built without specific encapsulation.
• The intrinsic elasticity of the dielectric film allows an
excellent compatibility of the capacitor with all types of
material for printed circuit boards.
• The self-healing property of film technology results to a
safety open failure mode and better overall reliability.
• Excellent thermal shock resistance.
• Low dissipation factor ESR & ESL.
• No piezoelectric effect.
• Available in tape and reel suitable for automatic placement.
• Non-polar construction.
55/125/56
1nF to 4.7μF
±5%, ±10%
25Vdc to 630Vdc
1.4Vr 2s to 25°C
IR or vapor phase reflow (not suitable for wave soldering)
< 100 x 10
-4
for C ≤ 0.33μF IR > 1000 MΩ at 20°C for 1 min. charge at 10Vdc
for VR < 100Vdc and 100Vdc for VR ≥ 100Vdc
for C > 0.33μF IR. C > 400sec. at 20°C for 1 min. charge at 10Vdc
for VR < 100Vdc and 100Vdc for VR ≥ 100Vdc
-55°C to 125°C with voltage derating of 1.25%/°C between 105°C and 125°C
Outer Layer
Termination Plating :
100% matte Sn
Ni Barrier Under
Termination
Silver Epoxy
Resin
Brass
Active Layers : PEN dielectric