AX88772_07 ASIX [ASIX Electronics Corporation], AX88772_07 Datasheet - Page 11

• Manufacturer Part Number: AX88772_07
• Description: USB to 10/100 Fast Ethernet/HomePNA Controller
• Manufacturer: ASIX [ASIX Electronics Corporation]

communicating with multiple PHY devices at the same time by identifying the managed PHY with 5-bit, unique Phy ID.
The Phy ID of the embedded 10/100 Ethernet PHY is being pre-assigned to “1_0000”.
Figure 4 shows the internal control mux for the station management interface. When doing read, the “mdin” signal will be
driven from 10/100 Ethernet PHY only if Phy ID matches with “1_0000”, otherwise, it will always be driven from
external MDIO pin of the ASIC.
3.5 Memory Arbiter
The memory arbiter block is responsible for storing received MAC frames into on-chip SRAM (packet buffer) and then
forwarding to USB bus upon request from USB host via bulk in transfer. It also monitors packet buffer usage in
full-duplex mode for triggering PAUSE frame transmission out on TX direction. The memory arbiter block is also
responsible for storing MAC frames received from USB host via bulk out transfer and waiting to be transmitted out
towards Ethernet network.
3.6 USB to Ethernet Bridge
The USB to Ethernet bridge block is responsible for converting Ethernet MAC frame into USB packets or vice-versa.
This block supports proprietary burst transfer mechanism (submitted for US patent application) to offload software
burden and to offer very high packet transfer throughput over USB bus.
3.7 Serial EEPROM Loader
The serial EEPROM loader is responsible for reading configuration data automatically from external serial EEPROM
after power-on reset.
3.8 General Purpose I/O
There are 3 general purpose I/O pins provided by this ASIC.
STA
Figure 4: Internal Control Mux for Station Management Interface
mdout
mdin
Phy ID = 1_0000
10/100 Ethernet
USB to 10/100 Fast Ethernet/HomePNA Controller
PHY
11
ASIX ELECTRONICS CORPORATION
MDC
MDIO
AX88772