WIZ610wi WIZnet, WIZ610wi Datasheet - Page 30

• Manufacturer Part Number: WIZ610wi
• Description: WiFi / 802.11 Modules 802.11B/G WIFI MOD
• Manufacturer: WIZnet

Specifications of WIZ610wi

• Rohs: yes
• Protocol Supported: 802.11 b/g
• Frequency Band: 2.4 GHz
• Data Rate: 11 Mbps, 54 Mbps
• Interface Type: Ethernet, UART
• Transmit Power (max): 16 dBm
• Antenna Connector Type: U.FL
• Operating Supply Voltage: 5 V
• Supply Current Transmitting: 480 mA
• Supply Current Receiving: 480 mA
• Maximum Operating Temperature: + 70 C
• Dimensions: 39 mm x 32 mm x 4.7 mm
• Minimum Operating Temperature: - 30 C
• Modulation Technique: DSSS, OFDM
• Security: AES, WEP, WPA, WPA2

the client to access. If you click the “Setup” button, page below appears.
Wireless Access Control Mode : This option allows you to enable or disable the “Wireless
Access Control Mode”. (Options: Disable / Allow Listed / Deny Listed)
Disable: Not use “Wireless Access Control Mode”.
Allow Listed: clients with their MAC registered in the Control List are permitted to access
WIZ610wi
Deny Listed: clients with their MAC registered in the Control List are denied to access
Preamble Type
Beacon Interval
Access Control : By registering the MAC address of a client, WIZ610wi blocks or allows
will not be enabled. The Router sends Request to Send (RTS)
frames to a particular receiving station and negotiates the sending
of a data frame. After receiving an RTS, the wireless station
responds with a Clear to Send (CTS) frame to acknowledge the
right to begin transmission. The RTS Threshold value should remain
as its default value of 2347.
The default value is 100. Enter a value between 1 and 65,535
milliseconds. The Beacon Interval value indicates the frequency
interval of the beacon. A beacon is a packet broadcast by the
Router to synchronize the wireless network.
Table 8. Wireless Advanced Settings
Figure 21. Wireless Access Control
22