WizFi210 WIZnet, WizFi210 Datasheet - Page 36

• Manufacturer Part Number: WizFi210
• Description: WiFi / 802.11 Modules 802.11B WIFI MOD LOW POWER
• Manufacturer: WIZnet

Specifications of WizFi210

• Rohs: yes
• Protocol Supported: 802.11 b/g/n
• Frequency Band: 2.4 GHz
• Data Rate: 11 Mbps
• Interface Type: I2C, SPI, UART
• Transmit Power (max): 8 dBm
• Antenna Connector Type: U.FL
• Operating Supply Voltage: 3.3 V
• Supply Current Transmitting: 135 mA
• Supply Current Receiving: 125 mA
• Maximum Operating Temperature: + 85 C
• Dimensions: 32 mm x 23.5 mm x 3 mm
• Minimum Operating Temperature: - 40 C
• Modulation Technique: CCK, DSSS
• Security: WEP, WPA, WPA2

Command
AT+NCTCP=
AT+NCUDP=
AT+NSTCP=
AT+NSUDP=
AT+CID=?
AT+NCLOSE=
AT+NCLOSEAL
L
AT+SETSOCKO
PT=
AT+SSLOPEN=
AT+SSLCLOSE
=
AT+HTTPCCO
NF=
AT+HTTPCOPE
N=
AT+HTTPCSEN
D=
AT+HTTPCCLO
SE=
AT+NRAW=
AT+UNSOLICIT
EDTX=
WizFi 210 User Manual
(8) Connection management
Parameters
<Dest-Address>,<Port>
<Dest-Address>,<Port>
[<,Src.Port>]
<Port>
<Port>
<CID>
<Cid>,<Type>,<Parameter>,<Valu
e>,<Length>
<cid>,<certificate name>
<cid>
<Param>,<Value>
<host>,<Port Number>, [<SSL
Flag>,<certificate name>]
<cid>,<Type>,<Timeout>,
<Page>,[Size of content]
<cid>
<0|1|2>
<Frame Control>,<Sequence
Cntrl>,<Channel>,<Rate>,<WmmI
nfo>, <Receiver Mac>,<Bssid of
(WIZnet Co., Ltd.)
Responses / Effects
Attempt TCP client connection to Destination;
CONNECT <CID> if successful.
Ex) AT+NCTCP=192.168.3.200,5000
Open UDP client socket to Destination;
CONNECT <CID> if successful.
Ex) AT+NCUDP=192.168.3.200,5000
Start a TCP server on Port; CONNECT <CID> if
successful.
Ex) AT+NSTCP=5000
UDP server on Port; CONNECT <CID> if
successful.
Ex) AT+NSUDP=5000
Returns the current CID configuration.
Close connection identified by CID.
Ex) AT+NCLOSE=1
Close all open connections.
Configure a socket which is identified by a Cid
Open an SSL connection
Close an SSL connection
Configure an HTTP client
Open an HTTP client connection. This
command opens an HTTP client on the
adaptor and connects to the server specified
by the host name or IP address
GET/POST HTTP data on the HTTP client
connection
Close the HTTP client connection
Enable / Disable Raw Ethernet support.
Unsolicited data transmission
30