AD6657AEBZ Analog Devices, AD6657AEBZ Datasheet - Page 35

• Manufacturer Part Number: AD6657AEBZ
• Description: Data Conversion IC Development Tools 11 Bit 200 Msps Quad IF Receiver
• Manufacturer: Analog Devices
• Type: ADCr
• Series: AD6657Ar

Specifications of AD6657AEBZ

• Rohs: yes
• Product: Evaluation Boards
• Tool Is For Evaluation Of: AD6657A
• Interface Type: SPI, USB
• Operating Supply Voltage: 6 V
• Description/function: Quad IF receiver with noise shaping requantizer
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Operating Supply Current: 2 A
• Factory Pack Quantity: 1
• For Use With: HSC-ADC-EVALCZ

Data Sheet
APPLICATIONS INFORMATION
DESIGN GUIDELINES
Before starting the design and layout of the
system, it is recommended that the designer become familiar
with these guidelines, which discuss the special circuit
connections and layout requirements needed for certain pins.
Power and Ground Recommendations
When connecting power to the AD6657A, it is recommended
that two separate 1.8 V supplies be used. Use one supply for
analog (AVDD); use a separate supply for the digital outputs
(DRVDD). The AVDD and DRVDD supplies should be isolated
with separate decoupling capacitors. Several different decoupling
capacitors can be used to cover both high and low frequencies.
Locate these capacitors close to the point of entry at the PCB
level and close to the pins of the part, with minimal trace length.
A single PCB ground plane is sufficient when using the AD6657A.
With proper decoupling and smart partitioning of the PCB
analog, digital, and clock sections, optimum performance is
easily achieved.
AD6657A
in a
Rev. 0 | Page 35 of 36
VCMx Pins
The VCMx pins are provided to set the common-mode level
of the analog inputs. Decouple the VCMx pins to ground with a
0.1 μF capacitor, as shown in Figure 37.
SPI Port
The SPI port should not be active during periods when the full
dynamic performance of the
SCLK signal, the CSB signal, and the SDIO signal are typically
asynchronous to the ADC clock, noise from these signals can
degrade
for other devices, it may be necessary to provide buffers between
this bus and the
tioning at the receiver inputs during critical sampling periods.
AD6657A
AD6657A
performance. If the on-board SPI bus is used
to prevent these signals from transi-
AD6657A
is required. Because the
AD6657A