AT28C256E-20UM/883 Atmel, AT28C256E-20UM/883 Datasheet - Page 3

IC EEPROM 256KBIT 200NS 28PGA

AT28C256E-20UM/883

Manufacturer Part Number
AT28C256E-20UM/883
Description
IC EEPROM 256KBIT 200NS 28PGA
Manufacturer
Atmel
Datasheet

Specifications of AT28C256E-20UM/883

Format - Memory
EEPROMs - Parallel
Memory Type
EEPROM
Memory Size
256K (32K x 8)
Speed
200ns
Interface
Parallel
Voltage - Supply
4.5 V ~ 5.5 V
Operating Temperature
-55°C ~ 125°C
Package / Case
28-PGA
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Other names
AT28C256E-20UM883
3. Block Diagram
4. Device Operation
4.1
4.2
4.3
4.4
0006M–PEEPR–12/09
Read
Byte Write
Page Write
DATA Polling
The AT28C256 is accessed like a Static RAM. When CE and OE are low and WE is high, the
data stored at the memory location determined by the address pins is asserted on the outputs.
The outputs are put in the high impedance state when either CE or OE is high. This dual-line
control gives designers flexibility in preventing bus contention in their system.
A low pulse on the WE or CE input with CE or WE low (respectively) and OE high initiates a write
cycle. The address is latched on the falling edge of CE or WE, whichever occurs last. The data is
latched by the first rising edge of CE or WE. Once a byte write has been started it will automati-
cally time itself to completion. Once a programming operation has been initiated and for the
duration of t
The page write operation of the AT28C256 allows 1 to 64 bytes of data to be written into the
device during a single internal programming period. A page write operation is initiated in the
same manner as a byte write; the first byte written can then be followed by 1 to 63 additional
bytes. Each successive byte must be written within 150 µs (t
limit is exceeded the AT28C256 will cease accepting data and commence the internal program-
ming operation. All bytes during a page write operation must reside on the same page as
defined by the state of the A6 - A14 inputs. For each WE high to low transition during the page
write operation, A6 - A14 must be the same.
The A0 to A5 inputs are used to specify which bytes within the page are to be written. The bytes
may be loaded in any order and may be altered within the same load period. Only bytes which
are specified for writing will be written; unnecessary cycling of other bytes within the page does
not occur.
The AT28C256 features DATA Polling to indicate the end of a write cycle. During a byte or page
write cycle an attempted read of the last byte written will result in the complement of the written
data to be presented on I/O7. Once the write cycle has been completed, true data is valid on all
outputs, and the next write cycle may begin. DATA Polling may begin at anytime during the write
cycle.
WC
, a read operation will effectively be a polling operation.
BLC
) of the previous byte. If the t
AT28C256
BLC
3

Related parts for AT28C256E-20UM/883