ZICM357SP0-1 CEL, ZICM357SP0-1 Datasheet

Page 1

... MeshConnect™ EM357 ZICM-EM35X-DEV-KIT-2 Development Kit The information in this document is subject to change without notice. Document No: 0011-00-07-00-000 (Issue E) Date Published: February 28, 2013 DATA SHEET MeshConnect™ EM357 Mini Modules ZICM357SP0-1, ZICM357SP2-1 Ember EM357 Transceiver Based Modules TM Development Kit available: ZICM-EM35X-DEV-KIT-2 MeshConnect ® Tx: ...

Page 2

... LPF Micro Radio EM35x Ember Companion Kit Description MeshConnect EM35x Ember Companion Kit for Ember EM35x Dev Kits PA TX/RX LPF Switch LNA MeshConnect ™ Kit Contents: • ZICM357SP2-1 modules (2) • ZICM357SP2-1C module (1) • ZICM357SP0-1 modules (2) • ZICM357SP0-1C module (1) • Online Documentation Page 2 ...

Page 3

TABLE OF CONTENTS Introduction and Overview Description.............................................................................................................................................................................................. Features.................................................................................................................................................................................................. Applications............................................................................................................................................................................................ Ordering Information............................................................................................................................................................................. Module Block Diagram........................................................................................................................................................................... Development Kit..................................................................................................................................................................................... System Level Function Transceiver IC......................................................................................................................................................................................... Antenna................................................................................................................................................................................................... Power Amplifier...................................................................................................................................................................................... Software/Firmware.................................................................................................................................................................................. Electrical Specification Absolute Maximum Ratings................................................................................................................................................................... Recommended (Operating Condition).................................................................................................................................................. DC Characteristics.................................................................................................................................................................................. RF Characteristics.................................................................................................................................................................................. Pin Signal and ...

Page 4

... ZigBee Point-to-Point network to perform Range and Packet Error Rate (PER) tests. The software can also place the module in various operating modes, which allows for setting and/or testing various parameters. The ZICM357SP0 uses the transceiver's Primary RF ports for transmitting and should use power mode 1. The ZICM357SP2 uses the transceiver's Alternate RF ports for transmitting and should use power mode 2. ...

Page 5

... ZICM357SP0 Receive Mode Current Transmit Mode Current @ 20dBm Transmit Mode Current @ 0dBm ZICM357SP2 Receive Mode Current Sleep Mode Current RF CHARACTERISTICS (@ 25⁰ C, VDD = 3.3V, ZICM357SP0 TX power mode 1, ZICM357SP2 TX power mode 2) Description General Characteristics RF Frequency Range RF Channels Frequency Error Tolerance Transmitter Maximum Output Power ...

Page 6

... GROUND Digital I/O TX_ACTIVE - Logic-level control for PA. The EM35x baseband controls TX_ PC5 ACTIVE and drives it high when in TX mode Applies only to the ZICM357SP0. PC5 the ZICM357SP2 RESET Active Low chip reset (Input) Digital I/O PC6 OSC32B - 32.768 kHz crystal oscillator ...

Page 7

... NC Note: PC5 Applies only to the ZICM357SP0; PC5 the ZICM357SP2. MeshConnect™ EM357 Mini Modules (Continued) Name Digital I/O SC1MISO - SPI slave data out of Serial Controller 1 SC1MOSI - SPI master data out of Serial Controller 1 PB1 SC1SDA - TWI data of Serial Controller 1 ...

Page 8

MODULE DIMENSIONS MeshConnect™ EM357 Mini Modules EM300 Series Module ZICM35xSPx 0000 000 C21 C21 C7 C7 Pin 1 C7B C7B R10 R10 C11 C11 L3 L3 C24 C24 C13 C13 C5B C5B C14 ...

Page 9

MODULE LAND FOOTPRINT Note: For layout recommendation for optimum antenna MeshConnect™ EM357 Mini Modules performance, refer to the Antenna section in this document. Page 9 ...

Page 10

PROCESSING Recommended Reflow Profile Parameters Values Ramp up rate (from Tsoakmax to Tpeak) Minimum Soak Temperature Maximum Soak Temperature Soak Time TLiquidus Time above TL Tpeak Time within 5º of Tpeak Time from 25º to Tpeak Ramp down rate Pb-Free ...

Page 11

... RF interference. AGENCY CERTIFICATIONS (PCB ANTENNA ONLY) The following Certifications are in effect: ZICM357SP0-1: FCC, IC, CE ZICM357SP2-1: FCC, IC FCC Compliance Statement (Part 15.19) Section 7.15 of RSS-GEN This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS Standards. Operation is subject to the following two conditions: 1 ...

Page 12

... Web de Santé Canada: CE Certification — Europe The MeshConnect ZICM357SP0 module has been tested and certified for use in the European Union. OEM Responsibility to the European Union Compliance Rules If the MeshConnect module incorporated into a product, the OEM must verify compliance of the final product to the European Harmonized EMC and Low-Voltage / Safety Standards. A Declaration of Conformity must be issued for each of these standards and kept on file as described in Annex II of the R& ...

Page 13

... If a customer is not starting with CEL's software development kit, they must implement these output power restrictions to use the ZICM357SP2 FCC or IC certification: Certification ZICM357SP0 ZICM357SP2 Note: For the ZICM357SP2, Power mode 2 with Power Setting "-2" is the maximum setting allowed for FCC compliance. ...

Page 14

... CEL does not assume any liability for infringement of patents, copyrights or other intellectual property rights of third parties by or arising from the use of CEL products listed in this document or any other liability arising from the use of such products. No license, express, implied or otherwise, is granted under any patents, copyrights or other intellectual property rights of CEL or others. • ...