MT48V8M16LFB4-8:G Micron Technology Inc, MT48V8M16LFB4-8:G Datasheet - Page 46

• Manufacturer Part Number: MT48V8M16LFB4-8:G
• Description: IC SDRAM 128MBIT 125MHZ 54VFBGA
• Manufacturer: Micron Technology Inc
• Type: Mobile SDRAMr

Specifications of MT48V8M16LFB4-8:G

• Format - Memory: RAM
• Memory Type: Mobile SDRAM
• Memory Size: 128M (8Mx16)
• Speed: 125MHz
• Interface: Parallel
• Voltage - Supply: 2.3 V ~ 2.7 V
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 54-VFBGA
• Organization: 8Mx16
• Density: 128Mb
• Address Bus: 14b
• Access Time (max): 19/8/7ns
• Maximum Clock Rate: 125MHz
• Operating Supply Voltage (typ): 2.5V
• Package Type: VFBGA
• Operating Temp Range: 0C to 70C
• Operating Supply Voltage (max): 2.7V
• Operating Supply Voltage (min): 2.3V
• Supply Current: 100mA
• Pin Count: 54
• Mounting: Surface Mount
• Operating Temperature Classification: Commercial
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

PDF: 09005aef807f4885/Source: 09005aef8071a76b
128Mbx16x32Mobile_2.fm - Rev. M 1/09 EN
10. READs or WRITEs listed in the Command (Action) column include READs or WRITEs with
11. Does not affect the state of the bank and acts as a NOP to that bank.
5. The following states must not be interrupted by any executable command; COMMAND
6. All states and sequences not shown are illegal or reserved.
7. Not bank-specific; requires that all banks are idle.
8. May or may not be bank-specific; if all banks are to be precharged, all must be in a valid
9. Not bank-specific; BURST TERMINATE affects the most recent READ or WRITE burst, regard-
INHIBIT or NOP commands must be applied on each positive clock edge during these states.
Refreshing starts with registration of an AUTO REFRESH command and ends when
met. After
state for precharging.
less of bank.
auto precharge enabled and READs or WRITEs with auto precharge disabled.
Accessing mode
Precharging all: Starts with registration of a PRECHARGE ALL command and ends
t
RFC is met, the SDRAM will be in the all banks idle state.
register:
Starts with registration of a LOAD MODE REGISTER command and
ends when
be in the all banks idle state.
when
t
46
RP is met. After
t
MRD has been met. After
Micron Technology, Inc., reserves the right to change products or specifications without notice.
t
RP is met, all banks will be in the idle state.
128Mb: x16, x32 Mobile SDRAM
t
MRD is met, the SDRAM will
©2001 Micron Technology, Inc. All rights reserved.
READs
t
RFC is