BATTERY PACK LITHIUM 6V W/LEADS

BR-E3C3BCA

Manufacturer Part NumberBR-E3C3BCA
DescriptionBATTERY PACK LITHIUM 6V W/LEADS
ManufacturerPanasonic - BSG
MSDS Material Safety Datasheet
 

Specifications of BR-E3C3BCA

Battery TypeLithiumVoltage - Rated6V
Capacity1200mAhBattery Cell SizePack with Leads
Number Of Cells1Termination StyleWire Leads with Connector
RechargeabilityNoSize / Dimension1.54" L x 0.87" W x 1.61" H (39.1mm x 22.1mm x 40.9mm)
Lead Free Status / RoHS StatusLead free / RoHS compliant by exemptionOther namesBR-E3CBCA
P203
1
Page 1
2
Page 2
Page 1/2

Download datasheet (25Kb)Embed
Next
Product Information Sheet
Panasonic Batteries
Panasonic Industrial Company
A Division Panasonic Corporation of North America
5201 Tollview Drive, 1F-3
Rolling Meadows, IL 60008
Toll Free:
877-726-2228
Fax:
847-637-4660
Internet:
www.panasonic.com/batteries
e-mail:
oembatteries@panasonic.com
The batteries referenced herein are exempt articles and are not subject to the OSHA Hazard
Communication Standard requirement. This sheet is provided as a service to our customers.
MSDS
Material Safety Data Sheets (MSDS) are a sub-requirement of the Occupational Safety and Health Administration
(OSHA) Hazard Communication Standard, 29 CFR Subpart 1910.1200. This Hazard Communication Standard does
not apply to various subcategories including anything defined by OSHA as an "article". OSHA has defined "article" as a
manufactured item other than a fluid or particle; (i) which is formed to a specific shape or design during manufacture; (ii)
which has end use function(s) dependent in whole or in part upon its shape or design during end use; and (iii) which
under normal conditions of use does not release more than very small quantities, e.g. minute or trace amounts of a
hazardous chemical, and does not pose a physical hazard or health risk to employees.
Because all of our batteries are defined as "articles", they are exempt from the requirements of the Hazard
Communication Standard; hence a MSDS is not required.
The following components are found in a Panasonic Poly-carbonmonofluoride (BR) Lithium battery:
Cylindrical Cell Components
Positive Electrode
Negative Electrode
Electrolyte
Coin Cell Components
Positive Electrode
Negative Electrode
Electrolyte
DISPOSAL
Lithium batteries are neither specifically listed nor exempted from the Federal Environmental Protection Agency (EPA)
hazardous waste regulations as promulgated by the Resource Conservation and Recovery Act (RCRA). The only metal
of possible concern in a lithium battery is lithium that is not a listed or characteristic toxic hazardous waste. Waste
lithium batteries can be considered a reactive hazardous waste if there is a significant amount of unreacted, or
unconsumed lithium remaining in the spent battery. The key to disposing of a lithium battery as a non-hazardous waste
is to guarantee that it is fully or mostly discharged. Once it is discharged it can be disposed of as non-hazardous waste.
You can dispose of a fully charged or partially discharged lithium battery as a hazardous waste after they are first
neutralized through an approved secondary treatment. The need for a secondary treatment prior to disposal is a
requirement of the U.S. Land Ban Restrictions of the Hazardous and Solid Waste Amendments of 1984. A secondary
treatment center can only receive these batteries as manifested hazardous waste. The waste code for charged lithium
Notice: The information and recommendations set forth are made in good faith and are believed to be accurate at the date of preparation.
Panasonic Industrial Company makes no warranty expressed or implied.
017-11
Product: Poly- carbonmonofluoride
(BR Type) Lithium Batteries
Applicable models/sizes: All BR type
cylindrical and coin batteries, except
our BR-C.
Revision: L January 1, 2011
Material
Poly-carbonmonofluoride
(CF)
Lithium
Li
y-Butyrolactone –Solvent
C
H
4
6
1,2 Dimethoxyethane-Solvent
C
H
4
10
Lithium Tetrafluroborate-Salt
LiBF
Material
Poly-carbonmonofluride
(CF)
Lithium
Li
y-Butyrolactone –Solvent
C
H
4
6
1,2 Dimethoxyethane-Solvent
C
H
4
10
Lithium Tetrafluroborate-Salt
LiBF
1 of 2
Formula
n
O
2
O
2
4
Formula
n
O
2
O
2
4

BR-E3C3BCA Summary of contents

  • Page 1

    ... Because all of our batteries are defined as "articles", they are exempt from the requirements of the Hazard Communication Standard; hence a MSDS is not required. The following components are found in a Panasonic Poly-carbonmonofluoride (BR) Lithium battery: Cylindrical Cell Components Positive Electrode ...

  • Page 2

    ... January 1, 2007 for consumer products. TRANSPORTATION Effective October 1, 2008 all Panasonic lithium batteries, except for our BR-C, are not subject to the requirements of the Department of Transportation (DOT) Subchapter C, Hazardous Materials Regulations if shipped in compliance with 49 CFR 173.185 and Special Provision 188. ...