W25X32VSFIG T&R Winbond Electronics, W25X32VSFIG T&R Datasheet - Page 16

• Manufacturer Part Number: W25X32VSFIG T&R
• Description: IC FLASH 32MBIT 75MHZ 16SOIC
• Manufacturer: Winbond Electronics

Specifications of W25X32VSFIG T&R

• Format - Memory: FLASH
• Memory Type: FLASH
• Memory Size: 32M (4M x 8)
• Speed: 75MHz
• Interface: SPI Serial
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 16-SOIC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

11.2 INSTRUCTIONS
The instruction set of the W25X16/32/64 consists of fifteen basic instructions that are fully controlled
through the SPI bus (see Instruction Set table). Instructions are initiated with the falling edge of Chip
Select (/CS). The first byte of data clocked into the DIO input provides the instruction code. Data on
the DIO input is sampled on the rising edge of clock with most significant bit (MSB) first.
Instructions vary in length from a single byte to several bytes and may be followed by address bytes,
data bytes, dummy bytes (don’t care), and in some cases, a combination. Instructions are completed
with the rising edge of edge /CS. Clock relative timing diagrams for each instruction are included in
figures 4 through 19. All read instructions can be completed after any clocked bit. However, all
instructions that Write, Program or Erase must complete on a byte boundary (CS driven high after a
full 8-bits have been clocked) otherwise the instruction will be terminated. This feature further protects
the device from inadvertent writes. Additionally, while the memory is being programmed or erased, or
when the Status Register is being written, all instructions except for Read Status Register will be
ignored until the program or erase cycle has completed.
11.2.1 Manufacturer and Device Identification
MANUFACTURER ID
Winbond Serial Flash
Device ID
Instruction
W25X16
W25X32
W25X64
(M7-M0)
EFH
(ID7-ID0)
ABh, 90h
14h
15h
16h
- 16 -
W25X16, W25X32, W25X64
(ID15-ID0)
9Fh
3015h
3016h
3017h