M29DW128F60ZA6E NUMONYX, M29DW128F60ZA6E Datasheet - Page 35

• Manufacturer Part Number: M29DW128F60ZA6E
• Description: IC FLASH 128MBIT 60NS 64TBGA
• Manufacturer: NUMONYX
• Series: Axcell™r

Specifications of M29DW128F60ZA6E

• Format - Memory: FLASH
• Memory Type: FLASH - Nor
• Memory Size: 128M (16Mx8, 8Mx16)
• Speed: 60ns
• Interface: Parallel
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-TBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

M29DW128F
6.2
Fast Program commands
The M29DW128F offers a set of Fast Program commands to improve the programming
throughput:
See either
summary of the Fast Program commands.
When V
Program mode. The user can then choose to issue any of the Fast Program commands.
Care must be taken because applying a V
any protected block.
Only one bank can be programmed at any one time. The other bank must be in Read mode
or Erase Suspend.
After programming has started, Bus Read operations in the Bank being programmed output
the Status Register content, while Bus Read operations to the other Bank output the
contents of the memory array. Fast program commands can be suspended and then
resumed by issuing a Program Suspend command and a Program Resume command,
respectively (see
Resume command
After the fast program operation has completed, the memory will return to the Read mode,
unless an error has occurred. When an error occurs Bus Read operations to the Bank
where the command was issued will continue to output the Status Register. A Read/Reset
command must be issued to reset the error condition and return to Read mode. One of the
Erase Commands must be used to set all the bits in a block or in the whole memory from ’0’
to ’1’.
Typical Program times are given in
Endurance
Write to Buffer and Program
Double and Quadruple Word, Program
Double, Quadruple and Octuple Byte Program
Unlock Bypass.
PPH
Table
Cycles.
is applied to the V
14, or
Section 6.1.9: Program Suspend command
paragraphs.)
Table
13, depending on the configuration that is being used, for a
PP
/Write Protect pin the memory automatically enters the Fast
Table 18: Program, Erase Times and Program, Erase
PPH
to the V
PP
/WP pin will temporarily unprotect
and
Section 6.1.10: Program
Command interface
35/94