MD2534-D2G-X-P SanDisk, MD2534-D2G-X-P Datasheet - Page 28

• Manufacturer Part Number: MD2534-D2G-X-P
• Description: IC MDOC H3 2GB FBGA
• Manufacturer: SanDisk

Specifications of MD2534-D2G-X-P

• Format - Memory: FLASH
• Memory Type: FLASH - Nand
• Memory Size: 2G (256M x 8)
• Interface: Parallel
• Voltage - Supply: 1.65 V ~ 1.95 V, 2.5 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 115-TFBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Speed: -

completion, mDOC H3 will respond only to accesses to the XIP Boot Block (including Paged or
Virtual RAM accesses) in order to facilitate completion of the IPL execution.
Once Embedded TrueFFS is loaded, executed and completed its media mount process, mDOC H3
is ready to be used as a fully functional storage device.
3.5
Since NAND-based flash is prone to errors, it requires unique error-handling capabilities to
ensure required reliability. msystems’ TrueFFS technology, embedded within mDOC H3,
includes a 6-bit Error Detection Code / Error Correction Code (EDC/ECC), based on the Bose,
Chaudhuri and Hocquenghem (BCH) algorithm. Both EDC and ECC are implemented in
hardware to optimize performance.
Each time a 512-byte sector is written, additional parity bits are calculated and written to the
flash. Each time data is read from the flash, the parity bits are read and used for calculating error
locations.
The BCH algorithm can detect and correct 6 errors per 512 Bytes, and in case of higher error
rates, will identify and notify a corrupted sector in very high probability. It ensures that the
minimal amount of code is used for detection and correction to deliver the required reliability
without degrading performance.
3.6
Block device management is performed by an embedded SW module, responsible for execution
of all Block Device operations, such as address calculation, erase, read and writes operations etc.
This module translates these operations from virtual media terms (i.e. sector addresses) to flash
media terms (i.e. flash planes, blocks and pages).
These Block Device operations are typically initiated by the host File System, translated by the
DOC Driver and sent to the device over the host interface. The Host Agent (above) is responsible
for capture and transfer to the Block Device management.
28
Error Detection Code / Error Correction Code (EDC/ECC)
Block Device Management
Data Sheet (Preliminary) Rev. 0.2
mDOC H3 Embedded Flash Drive
92-DS-1205-10