MD2534-D2G-X-P SanDisk, MD2534-D2G-X-P Datasheet - Page 51

• Manufacturer Part Number: MD2534-D2G-X-P
• Description: IC MDOC H3 2GB FBGA
• Manufacturer: SanDisk

Specifications of MD2534-D2G-X-P

• Format - Memory: FLASH
• Memory Type: FLASH - Nand
• Memory Size: 2G (256M x 8)
• Interface: Parallel
• Voltage - Supply: 1.65 V ~ 1.95 V, 2.5 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 115-TFBGA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Speed: -

7.3.18 Endian Control Register
Description:
Address (hex): 9412 (128KB window) / 1412 (8KB window)
Type:
Note: This register cannot be accessed when the A0 signal is pulled high. Therefore it is
7.3.19 Version Register
Description:
Address (hex): 941A (128KB window) / 141A (8KB window)
Type:
Note: This register cannot be accessed when the A0 signal is pulled high. Therefore it is
51
Bit number
Read/Write
Bit name
Reset value
SWAP
Bit number
Read/Write
Bit name
Reset value
Version
recommended that A0 will be connected to Host CPU A0, or to VSS.
recommended that A0 will be connected to Host CPU A0, or to VSS.
This 16-bit register is used to control the swapping of the low and high data
bytes when reading or writing with a 16-bit host. This provides an Endian-
independent method of enabling/disabling the byte swap feature.
Read / Write
This 16-bit register reports the mDOC H3 version.
Read / Write
D15-D0
R
Version
0
D15-D9
R
RFU
0
Version number
Swap enable per byte. (This bit can be set by setting bit-0 OR bit-8).
To clear the bit both bits 0 & 8 need to be cleared to ‘0’;
0: Data from host is unchanged.
1: Data from host is swapped.
Data Sheet (Preliminary) Rev. 0.2
D8
R/W
SWAP
0
D7-D1
R
RFU
0
D0
R/W
SWAP
0
mDOC H3 Embedded Flash Drive
92-DS-1205-10