VIPER53DIP-E STMicroelectronics, VIPER53DIP-E Datasheet - Page 30

• Manufacturer Part Number: VIPER53DIP-E
• Description: IC OFFLINE SWIT PWM CM OTP 8DIP
• Manufacturer: STMicroelectronics
• Series: VIPER™r
• Type: Pulse Width Modulator Controllerr

Specifications of VIPER53DIP-E

• Output Isolation: Isolated
• Frequency Range: 93 ~ 300kHz
• Voltage - Input: 8.4 ~ 19 V
• Voltage - Output: 620V
• Power (watts): 30W
• Operating Temperature: 25°C ~ 125°C
• Package / Case: 8-DIP (0.300", 7.62mm)
• Current, Supply: 9 mA
• Frequency, Oscillator: 100 kHz
• Package Type: DIP-8
• Regulator Type: Switching
• Resistance, Thermal, Junction To Case: 20 °C/W
• Temperature, Operating, Range: -40 to +150 °C
• Time, Fall: 100 ns
• Time, Rise: 50 ns
• Voltage, Supply: 13 V
• Power Switch Family: VIPer53DIP
• Input Voltage: 0 to 19V
• Power Switch On Resistance: 900mOhm
• Output Current: 1.6A
• Number Of Outputs: Single
• Mounting: Through Hole
• Supply Current: 9mA
• Operating Temperature (min): -40C
• Operating Temperature (max): 150C
• Operating Temperature Classification: Automotive
• Pin Count: 8
• Mounting Style: Through Hole
• For Use With: 497-8435 - BOARD EVAL FOR VIPER53 28W497-6458 - BOARD EVAL BASED ON VIPER53-E497-6262 - BOARD REF SGL VIPER53 90-264VAC497-5866 - EVAL BOARD 24W NEG OUT VIPER53E
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-6171-5

Special recommendations
12
13
30/36
Special recommendations
As steted in the error amplifier section, a capacitor of 10nF capacitor (minimum value: 8nF)
should always be connected to the COMP pin to ensure correct stability of the internal error
amplifier
In order to improve the ruggedness of the device versus eventual drain overvoltages, a
resistance of 1k should be inserted in series with the TOVL pin, as shown on
Figure 19 on page
Note that, this resistance does not impact the overload delay, as its value is negligible prior
to the internal pull-up resistance (about 125k ).
Software implementation
All the above considerations and some others are included included in ST design software
which provides all of the needed components around the VIPer device for specified output
configurations, and is available on
Figure
18,
17.
19
and 22.
www.st.com.
Figure
VIPer53 - E
18,