LM2596T-3.3/NOPB National Semiconductor, LM2596T-3.3/NOPB Datasheet - Page 9

• Manufacturer Part Number: LM2596T-3.3/NOPB
• Description: IC REG SIMPLE SWITCHER TO-220-5
• Manufacturer: National Semiconductor
• Series: SIMPLE SWITCHER®r
• Type: Step-Down (Buck)r

Specifications of LM2596T-3.3/NOPB

• Internal Switch(s): Yes
• Synchronous Rectifier: No
• Number Of Outputs: 1
• Voltage - Output: 3.3V
• Current - Output: 3A
• Frequency - Switching: 150kHz
• Voltage - Input: 4.5 ~ 40 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Through Hole
• Package / Case: TO-220-5 (Bent and Staggered Leads)
• For Use With: 551011367-041 - BOARD WEBENCH BUILD IT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Power - Output: -
• Other names: *LM2596T-3.3; *LM2596T-3.3/NOPB; LM2596T-3.3

Test Circuit and Layout Guidelines
where V
Select R
C
C
D1
L1
R1
C
As in any switching regulator, layout is very important. Rap-
idly switching currents associated with wiring inductance can
generate voltage transients which can cause problems. For
minimal inductance and ground loops, the wires indicated by
heavy lines should be wide printed circuit traces and
should be kept as short as possible. For best results,
external components should be located as close to the
switcher lC as possible using ground plane construction or
single point grounding.
If open core inductors are used, special care must be
taken as to the location and positioning of this type of induc-
tor. Allowing the inductor flux to intersect sensitive feedback,
lC groundpath and C
IN
OUT
FF
— 68 µH, L38
— 5A, 40V Schottky Rectifier, 1N5825
— 1 k , 1%
— 470 µF, 50V, Aluminum Electrolytic Nichicon “PL Series”
— See Application Information Section
— 220 µF, 35V Aluminum Electrolytic, Nichicon “PL Series”
REF
1
to be approximately 1 k , use a 1% resistor for best stability.
= 1.23V
OUT
wiring can cause problems.
FIGURE 1. Standard Test Circuits and Layout Guides
Adjustable Output Voltage Versions
(Continued)
9
When using the adjustable version, special care must be
taken as to the location of the feedback resistors and the
associated wiring. Physically locate both resistors near the
IC, and route the wiring away from the inductor, especially an
open core type of inductor. (See application section for more
information.)
01258323
www.national.com