KS8993M Micrel Inc, KS8993M Datasheet - Page 24

• Manufacturer Part Number: KS8993M
• Description: IC SWITCH 10/100 3PORT 128PQFP
• Manufacturer: Micrel Inc

Specifications of KS8993M

• Applications: *
• Mounting Type: Surface Mount
• Package / Case: 128-MQFP, 128-PQFP
• Number Of Primary Switch Ports: 3
• Internal Memory Buffer Size: 32
• Operating Supply Voltage (typ): 1.8/2.5/3.3V
• Fiber Support: Yes
• Integrated Led Drivers: Yes
• Phy/transceiver Interface: MII/SNI
• Power Supply Type: Analog/Digital
• Package Type: PQFP
• Data Rate (typ): 10/100Mbps
• Vlan Support: Yes
• Operating Temperature (max): 70C
• Operating Temperature (min): 0C
• Pin Count: 128
• Mounting: Surface Mount
• Jtag Support: No
• Operating Supply Voltage (max): 1.89/3.465V
• Operating Supply Voltage (min): 1.71/3.135V
• Power Dissipation: 800mW
• Supply Current: 0.1/0.19A
• Operating Temperature Classification: Commercial
• Data Rate: 100Mbps
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 576-1013 - BOARD EVAL EXPERIMENT KS8993M
• Lead Free Status / RoHS Status: Not Compliant, Lead free / RoHS Compliant

Crossover Cable
A crossover cable connects an MDI device to another MDI device, or an MDI-X device to another MDI-X device.
The following diagram shows a typical crossover cable connection between two switches or hubs (two MDI-X
devices).
Auto Negotiation
The KS8993M conforms to the auto negotiation protocol as described by the 802.3 committee. Auto negotiation
allows unshielded twisted pair (UTP) link partners to select the best common mode of operation. In auto
negotiation, the link partners advertise capabilities across the link to each other. If auto negotiation is not
supported or the link partner to the KS8993M is forced to bypass auto negotiation, then the mode is set by
observing the signal at the receiver. This is known as parallel mode because while the transmitter is sending auto
negotiation advertisements, the receiver is listening for advertisements or a fixed signal protocol.
The link setup is shown in the following flow diagram.
Micrel, Inc.
April 2005
Media Dependent Interface
Modular Connector (RJ-45)
Transmit Pair
Receive Pair
(Repeater or Switch)
10/100 Ethernet
HUB
Figure 2. Typical Crossover Cable Connection
1
2
3
4
5
6
7
8
Crossover
Cable
24
Media Dependent Interface
Modular Connector (RJ-45)
(Repeater or Switch)
1
2
3
4
5
6
7
8
10/100 Ethernet
Transmit Pair
HUB
Receive Pair
KS8993M/ML/MI
M9999-041205