PS2705-1-F3-A

Manufacturer Part NumberPS2705-1-F3-A
DescriptionOPTOISOLATOR 1CH TRANS OUT 4-SOP
ManufacturerCEL
SeriesNEPOC
PS2705-1-F3-A datasheet
 


Specifications of PS2705-1-F3-A

Number Of Channels1Input TypeAC, DC
Voltage - Isolation3750VrmsCurrent Transfer Ratio (min)50% @ 5mA
Current Transfer Ratio (max)300% @ 5mAVoltage - Output40V
Current - Output / Channel80mACurrent - Dc Forward (if)±50mA
Vce Saturation (max)300mVOutput TypeTransistor
Mounting TypeSurface MountPackage / Case4-SOP
Isolation Voltage3750 VrmsLead Free Status / RoHS StatusLead free / RoHS Compliant
Other namesPS2705-1ATR  
1
Page 1
2
Page 2
3
Page 3
4
Page 4
5
Page 5
6
Page 6
7
Page 7
8
Page 8
9
Page 9
10
Page 10
11
12
13
14
Page 10/14

Download datasheet (208Kb)Embed
PrevNext
NOTES ON HANDLING
1. Recommended soldering conditions
(1) Infrared reflow soldering
• Peak reflow temperature
• Time of peak reflow temperature
• Time of temperature higher than 220°C
• Time to preheat temperature from 120 to 180°C
• Number of reflows
• Flux
Recommended Temperature Profile of Infrared Reflow
120˚C
(2) Wave soldering
• Temperature
260°C or below (molten solder temperature)
• Time
10 seconds or less
• Preheating conditions
120°C or below (package surface temperature)
• Number of times
One (Allowed to be dipped in solder including plastic mold portion.)
• Flux
Rosin flux containing small amount of chlorine (The flux with a maximum chlorine
content of 0.2 Wt% is recommended.)
(3) Soldering by soldering iron
• Peak temperature (lead part temperature)
• Time (each pins)
• Flux
(a) Soldering of leads should be made at the point 1.5 to 2.0 mm from the root of the lead.
(b) Please be sure that the temperature of the package would not be heated over 100°C.
10
260°C or below (package surface temperature)
10 seconds or less
60 seconds or less
120±30 s
Three
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
(heating)
to 10 s
to 60 s
180˚C
120±30 s
(preheating)
Time (s)
350°C or below
3 seconds or less
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
Data Sheet PN10243EJ02V0DS
PS2705-1
260˚C MAX.
220˚C