LQ035Q7DB03 Sharp Microelectronics, LQ035Q7DB03 Datasheet - Page 19

• Manufacturer Part Number: LQ035Q7DB03
• Description: LCD TFT 3.5" 240X320 QVGA
• Manufacturer: Sharp Microelectronics

Specifications of LQ035Q7DB03

• Display Type: LCD - Color
• Display Mode: *
• Viewing Area: 71.52mm L x 53.64mm W
• Dot Pixels: 320 x 240 (QVGA)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Interface: -
• Backlight: -
• Dot Size: -
• Dot Pitch: -
• Other names: 425-2481

sharp
(12)Handling Precautions
12-1) Insertion and taking out of FPCs
12-2) Handling of FPCs
12-3) Installation of the module
12-4)Precaution when mounting
12-5)Others
(1) If water droplets and oil attaches to it for a long time, discoloration and staining occurs. Wipe them off
(2) Glass is used for the TFT-LCD panel. If it is dropped or bumped against a hard object, it may be broken.
(3)As the CMOS IC is used in this module, pay attention to static electricity when handling it. Take a
measure for grounding on the human body.
(1) The liquid-crystal is deteriorated by ultraviolet rays. Do not leave it in direct sunlight and strong
(2) If it is kept at a temperature below the rated storage temperature, it becomes coagulated and the panel
(3) If the LCD breaks, don’t put internal liquid crystal into the mouth. When the liquid crystal sticks to the
(4) Wipe off water drop or finger grease immediately. Long contact with water may cause discoloration or
(5) Observe general precautions for all electronic components.
(6) VCOM must be adjusted on condition of your final product. No adjustment causes the deterioration for
(7) Static image should not be displayed more than 5 minutes in order to prevent from occurrence of
On mounting the module, be sure to fix the module on the same plane. Taking care not to warp or
twist the module.
supply on the set side.
on the whole slit portion with bending radius larger than 0.6mm ,and only inner side (back side
of the module). Don’t bend it outer side (display surface side).
Be sure insert and take out of the FPC into the connector of the set after turning off the power
Don’t give the FPCs too large force, for example, hanging the module with holding FPC.
immediately.
Handle it with sufficient care.
ultraviolet rays for many hours.
may be broken. Also, if it is kept at a temperature above the rated storage temperature, it becomes
isotropic liquid and does not return to its original state. Therefore, it is desirable to keep it at room
temperature as much as possible.
hands, feet and clothes, wash it out immediately.
spots.
display quality.
residual image.
The FPC for LCD panel shall be bent only slit portion. The bending slit shall be bent uniformly
LCP-02013−16