CDB48500-USB Cirrus Logic Inc, CDB48500-USB Datasheet - Page 11

• Manufacturer Part Number: CDB48500-USB
• Description: KIT USB EVALUATION FOR CDB48500
• Manufacturer: Cirrus Logic Inc

Specifications of CDB48500-USB

• Main Purpose: Audio, Audio Processing
• Embedded: No
• Utilized Ic / Part: CS485XX
• Primary Attributes: 32-Bit Audio Processor, I2C or SPI
• Secondary Attributes: Graphic User Interface, 12-ch Analog Audio Input & Outputs, Optical Out- S/PDIF
• Description/function: Audio A/D
• Operating Supply Voltage: 9 V to 12 V
• Product: Audio Modules
• Supply Current: 1 A
• For Use With/related Products: CS48520, CS48540, CS48560
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant
• Other names: 598-1284

Introduction
CDB48500-USB Evaluation Kit Guide
2-1
2.1 Introduction
2.1.1 Installing the Evaluation Kit Software
The DSP evaluation software installation will first install the Cirrus Logic DSP evaluation software followed
by the USB drivers required to communicate with the CDB USB MASTER.
1. Run the latest DSP evaluation software installation executable (CS4853x_EVAL_V02_03_07.exe or
2. At the Welcome screen, click Next.
3. At the Licensing Agreement window, select the “I accept the agreement” radio button to agree to
4. Select the Destination Location window, Select the default location “C:\CirrusDSP” and click Next.
5. Select Start Menu Folder window, Select the default location “C:\CirrusDSP” and click Next.
6. The Ready to Install window indicates the selected destination location and the Start menu folder for
7. After the DSP evaluation software is installed, the installer will launch the Front Panel Driver Setup
later). This executable is supplied by your Cirrus Logic representative.
the terms and then select Next.
confirmation, select Install to begin the install process which should take less than one minute.
It is important to install the Evaluation Software BEFORE connecting the USB cable from the PC to
the CDB USB MASTER card. Failure to install the evaluation software before the initial connection
can result in an inability to communicate with the CBD485xx.
Board Setup and Installing the Evaluation Kit Software
©
Copyright 2008 Cirrus Logic , Inc.
Chapter 2
DS784DB1