STEVAL-MKI062V2 STMicroelectronics, STEVAL-MKI062V2 Datasheet - Page 13

• Manufacturer Part Number: STEVAL-MKI062V2
• Description: BOARD EVAL FOR MEMS SENSORS
• Manufacturer: STMicroelectronics
• Series: iNEMOr

Specifications of STEVAL-MKI062V2

• Design Resources: STEVAL-MKI062V2 Gerber Files STEVAL-MKI062V2 Schematic STEVAL-MKI062V2 Bill of Materials
• Sensor Type: Accelerometer, Gyroscope, Magnetometer, Pressure, Temperature
• Sensing Range: ±2g,4g,8g; 300 ~ 1100mbar; 300°/sec; -55 ~125°C
• Interface: I²C, USB
• Sensitivity: Multiple
• Voltage - Supply: 5V, USB
• Embedded: Yes, MCU, 32-Bit
• Utilized Ic / Part: LPR430AL, LY330ALH, LSM303DLH, LPS001DL, STM32F103RE, STLM75
• Interface Type: USB, CAN, I2C
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 55 C
• Silicon Manufacturer: STMicroelectronics
• Kit Application Type: Sensor
• Application Sub Type: MEMS Device
• Silicon Family Name: INEMO
• Kit Contents: MicroSD Card Slot, COM Connector, Reset Button,
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: STM32F103RE
• Other names: 497-10508

UM0701
5.2.2
5.2.3
Figure 9.
Setup for analog MEMS
Position the JP5, JP13 and JP14 jumpers on the STM32-MEMS board.
No modification is needed on the STM3210E-EVAL board.
Figure 10. Setup for analog MEMS
Setup for digital MEMS - SPI interface
Position the JP5, JP6, JP9 and JP11 jumpers on the STM32-MEMS board.
If Int1 signal is used
Position the JP10 jumper on the STM32-MEMS board.
Remove the SD card from the CN13 card socket on the STM3210E-EVAL board.
STM3210E-EVAL board with STM32-MEMS board connected
Doc ID 15703 Rev 1
System setup
13/42