CAPTOUCHSENSESK Silicon Laboratories Inc, CAPTOUCHSENSESK Datasheet - Page 6

KIT STARTER CAP TOUCH SENSE

CAPTOUCHSENSESK

Manufacturer Part Number
CAPTOUCHSENSESK
Description
KIT STARTER CAP TOUCH SENSE
Manufacturer
Silicon Laboratories Inc
Series
ToolStickr
Datasheet

Specifications of CAPTOUCHSENSESK

Sensor Type
Touch, Capacitive
Interface
USB
Embedded
Yes, MCU, 8-Bit
Utilized Ic / Part
C8051F931
Accessory Type
Cap Touch Sense Starter Kit
Silicon Family Name
C8051F93x?
Silicon Manufacturer
Silicon Labs
Core Sub-architecture
80C51
Core Architecture
8051
Rohs Compliant
Yes
Development Tool Type
Hardware / Software - Starter Kit
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Voltage - Supply
-
Sensitivity
-
Sensing Range
-
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
For Use With
C8051F931
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Lead free / RoHS Compliant
Other names
336-1475
ToolSt ick-CapTouchSenseDC
6. ToolStick CapTouchSense Daughter Card Memory Game Demo
The ToolStick CapTouchSense Daughter Card is pre-loaded with a memory game firmware that can be played
without connecting to the ToolStick Base Adapter. When disconnected from the ToolStick Base Adapter, the
daughter card may be powered from the included A76 alkaline battery. When connected to a ToolStick Base
Adapter, the daughter card can be powered from the USB port.
6.1. Hardware Setup
To use the CapTouchSense Daughter Card in standalone mode (battery powered) perform the following steps:
1. Insert the A76 alkaline “button cell” battery into the battery holder (BAT1) ensuring that the “+” terminal is on the
2. Set the Power Select Switch (S1) to select Battery Power (BAT PWR). The yellow power source indicator LED
To use the CapTouchSense Daughter Card with a ToolStick Base Adapter (USB powered) perform the following
steps:
1. Connect the ToolStick Base Adapter to the ToolStick CapTouchSense Daughter Card taking note of the
2. If available, connect the USB extension cable to the ToolStick Base Adapter.
3. Set the Power Select Switch (S1) to select ToolStick Power (TS PWR). The yellow power source indicator LED
4. Connect the ToolStick to a USB port on a PC.
See Figure 5 for an example hardware setup using the C8051F330 ToolStick Daughter Card.
6
top side as marked on the battery holder.
should be OFF.
recommendations in Section 1.
should be ON.
Figure 5. Hardware Setup Example
Rev. 0.2

Related parts for CAPTOUCHSENSESK