ATSTK600 Atmel, ATSTK600 Datasheet - Page 14

• Manufacturer Part Number: ATSTK600
• Description: DEV KIT FOR AVR/AVR32
• Manufacturer: Atmel
• Series: AVR®r
• Type: MCUr

Specifications of ATSTK600

• Processor To Be Evaluated: AVR and AVR32
• Data Bus Width: 8 bit
• Interface Type: RS-232, USB
• Silicon Manufacturer: Atmel
• Core Architecture: AVR
• Core Sub-architecture: AVR UC3
• Silicon Core Number: STK600
• Silicon Family Name: AVR
• Kit Contents: Board
• Rohs Compliant: Yes
• For Use With/related Products: Atmel AVR Devices
• For Use With: ATSTK600-ATTINY10 - STK600-ATTINY10 SOCKET PACKAGE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Contents: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

Table 4-18. Answer format.
5 Parallel Programming Mode Commands
5.1 CMD_ENTER_PROGMODE_PP
Table 5-1. Command format.
Field
NumTx
NumRx
RxStartAddr
TxData
Field
Answer ID
Status1
data
Status2
Field
Command ID
stabDelay
progModeDelay
latchCycles
toggleVtg
powerOffDelay
resetDelayMs
resetDelayUs
14
AVR079
Size
1 byte
1 byte
1 byte
1 byte
1 byte
1 byte
1 byte
1 byte
Size
1 byte
1 byte
1 byte
0-255 bytes
Size
1 byte
1 byte
0-255 bytes
1 byte
Values
CMD_ENTER_PROGMODE_PP
XML: stabDelay
XML: progModeDelay
XML: latchCycles
XML: toggleVtg
XML: powerOffDelay
XML: resetDelayMs
XML: resetDelayUs
If the number of bytes to receive is greater than number of bytes to transmit, then the
firmware will pad with the necessary 0x00 bytes. This is in order to save time-
consuming transfer from PC to the programmer.
This command will make the target device enter programming mode if it succeeds.
XML PATH: /AVRPART/ICE_SETTINGS/STK600/PpEnterProgMode/
Values
Values
STATUS_CMD_OK
STATUS_CMD_OK
0-255
0-255
CMD_SPI_MULTI
Description
Command id
Delay (in ms) used for pin stabilization
Delay (in ms) in connection with the EnterProgMode
command execution
Number of xtal cycles used to latch OSCCAL
Toggle Vtg when entering prog.mode (0=no, 1=yes). For
parts with RSTDSBL functionality
Power-off delay. Additional delay (in ms) after Vtg is turned
off in order to make sure the Vtg is low enough
RSTDELAY #1 (in ms) Additional delay between Vtg is
turned on and reset goes high.
RSTDELAY #2(in us x 10) Additional delay between Vtg is
turned on and reset goes high. Total delay is RSTDELAY
#1 (ms) + RSTDELAY #2 (us x 10)
Description
Number of bytes to transmit
Number of bytes to receive
Start address of returned data. Specifies on what
transmitted byte the response is to be stored and
returned.
The data to be transmitted. The size is specified
by NumTx
Description
Answer id
Will always read OK
The data read from the ISP bus as indicated in
the command
Will always read OK
8133A-AVR-04/08