ATSTK600 Atmel, ATSTK600 Datasheet - Page 20

• Manufacturer Part Number: ATSTK600
• Description: DEV KIT FOR AVR/AVR32
• Manufacturer: Atmel
• Series: AVR®r
• Type: MCUr

Specifications of ATSTK600

• Processor To Be Evaluated: AVR and AVR32
• Data Bus Width: 8 bit
• Interface Type: RS-232, USB
• Silicon Manufacturer: Atmel
• Core Architecture: AVR
• Core Sub-architecture: AVR UC3
• Silicon Core Number: STK600
• Silicon Family Name: AVR
• Kit Contents: Board
• Rohs Compliant: Yes
• For Use With/related Products: Atmel AVR Devices
• For Use With: ATSTK600-ATTINY10 - STK600-ATTINY10 SOCKET PACKAGE
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Contents: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

5.14 CMD_SET_CONTROL_STACK
Table 5-20. Command format.
Table 5-21. Answer format if command was executed.
6 High Voltage Serial Programming Commands
6.1 CMD_ENTER_PROGMODE_HVSP
Table 6-1. Command format.
Field
Command ID
Data
Field
Answer ID
Status
Field
Command ID
StabDelay
CmdexeDelay
SynchCycles
LatchCycles
ToggleVtg
20
AVR079
Size
1 byte
32byte
Size
1 byte
1 byte
Size
1 byte
1 byte
1 byte
1 byte
1 byte
1 byte
This command uploads the control stack to the STK. This is used for both PP and
HVSP.
Note: The Control stack must always be uploaded before performing any
programming commands in high voltage mode if the STK600 has been powered
down.
To
PARAM_CONTROLLER_INIT.
Se chapter 11.7: PARAM_CONTROLLER_INIT
This chapter describes the High Voltage Serial Programming (HVSP) commands.
Note that the SetControlStack command is required for HVSP as for PP. Description
of the SetControlStack is found in chapter 5.14 CMD_SET_CONTROL_STACK
This command will make the target device enter programming mode if it succeeds.
XML path: /AVRPART/ICE_SETTINGS/STK600/HvspEnterProgMode/
check
Values
CMD_SET_CONTROL_STACK
Values
CMD_SET_CONTROL_STA
CK
STATUS_CMD_OK
Values
CMD_ENTER_PROGMODE_H
VSP
XML: stabDelay
XML: cmdexeDelay
XML: latchCycles
XML: synchCycles
XML: toggleVtg
if
the
controller
has
Description
Command id
Control stack Data
Description
Answer id
A Result Value indicating the result of the
operation
Description
Command id
Delay (in ms) used for pin stabilization
Delay (in ms) in connection with the
EnterProgMode command execution
Number of synchronization clock cycles
Number of PulseXtal1_HVSP cycles
Toggle Vtg when entering prog.mode (0=no,
1=yes). For parts with RSTDSBL functionality
a
valid
control
stack:
8133A-AVR-04/08
Read