ICS309 Integrated Circuit System, ICS309 Datasheet

no-image

ICS309

Manufacturer Part Number
ICS309
Description
Manufacturer
Integrated Circuit System
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
ICS309RLF
Manufacturer:
NXP
Quantity:
490
MDS 309 A
In tegr ated C ir c uit S ystems
Description
The ICS309 is a versatile serially programmable, triple
PLL with spread spectrum clock source. The ICS309
can generate any frequency from 250kHz to 200 MHz,
and up to 6 different output frequencies simultaneously.
The outputs can be reprogrammed on the fly, and will
lock to a new frequency in 10 ms or less.
To reduce system EMI emissions, spread spectrum is
available that supports modulation frequencies of
31 kHz and 120 kHz, as well as modulation amplitudes
of +/-0.25% to +/-2.0%. Both center- and down-spread
options are available.
The device includes a PDTS pin which tri-states the
output clocks and powers down the entire chip.
The ICS309 default for non-programmed start-up are
buffered reference clock outputs on all clock output
pins.
ICS’ VersaClock
user to configure up to 9 outputs with target
frequencies, spread spectrum capabilities or buffered
reference clock outputs. The VersaClock
Block Diagram
X 1/IC L K
STROBE
X 2
TM
DATA
SCLK
programming software allows the
525 R ace St reet , S an Jose, CA 95126
O scillator
P r e l i m i n a r y I n f o r m a t i o n
C rystal
S
TM
ERIAL
software
P LL1 w ith
S pectrum
1
G N D
P
S pread
P LL3
P LL2
V D D
ROGRAMMABLE
automatically configures the PLLs for optimal overall
performance.
Features
3
2
Packaged in 20 pin SSOP (QSOP)
Highly accurate frequency generation
Serially programmable: user determines the output
frequency via a 3 wire interface
Spread Spectrum frequency modulation for reduced
system EMI
Eliminates need for custom quartz oscillators
Input crystal frequency of 5 - 27 MHz
Output clock frequencies up to 200 MHz
Operating voltage of 3.3 V
Up to 9 reference clock outputs
Optional programmable on-chip crystal capacitors
M/N Multiplier PLL: M = 1..2048, N = 1..1024
Center or Down Spread up to 4% total
Selectable 32kHz and 120kHz modulation
Control
Enable
Output
Divide
Logic
and
P D TS
te l (40 8) 29 5-980 0
T
RIPLE
CLK1
CLK2
CLK3
CLK4
CLK5
CLK6
CLK7
CLK8
CLK9
SS C
ICS309
w ww. ic s t .c o m
Revision 053003
LOCK

Related parts for ICS309

ICS309 Summary of contents

Page 1

... Description The ICS309 is a versatile serially programmable, triple PLL with spread spectrum clock source. The ICS309 can generate any frequency from 250kHz to 200 MHz, and different output frequencies simultaneously. The outputs can be reprogrammed on the fly, and will lock to a new frequency less. ...

Page 2

... Output clock 5. Default of Reference frequency output when unprogrammed. Connect to Ground. Connect to +3.3V. Connect to +3.3V. Powers down entire chip, tri-states all outputs when low. Internal pull-up. Serial Shift register clock. See timing diagram. Strobe to load data. See timing diagram. 2 ICS309 ROGRAMMABLE RIPLE Pin Description Revision 053003 ...

Page 3

... DATA pin in this order: MSB (left most bit) first. As show in Figure 2, after these 160 bits are clocked into the ICS309, taking STROBE high will send this data to the internal hatch and the CLK output will lock within 10 ms. ...

Page 4

... The nominal impedance of the clock output Decoupling Capacitors As with any high performance mixed-signal IC, the ICS309 must be isolated from system power supply noise to perform optimally. Decoupling capacitors of 0.01µF must be connected between each VDD and the PCB ground plane. Crystal Load Capacitors ...

Page 5

... ICS309 Configuration Capabilities The architecture of the ICS309 allows the user to easily configure the device to a wide range of output frequencies, for a given input reference frequency. The frequency multiplier PLL provides a high degree of precision ...

Page 6

... Absolute Maximum Ratings Stresses above the ratings listed below can cause permanent damage to the ICS309. These ratings, which are standard values for ICS commercially rated parts, are stress ratings only. Functional operation of the device at these or any other conditions above those indicated in the operational sections of the specifications is not implied ...

Page 7

... PDTS goes high until stable CLK out t Reference Clock j t All other clocks Configuration dependent Symbol Conditions Still air JA 1 m/s air flow JA 3 m/s air flow ICS309 ROGRAMMABLE RIPLE Min. Typ. Max. Units 2.4 0.4 VDD-0.4 +70 4 525 250 Min. Typ. ...

Page 8

... ICS309R ICS308R YYWW (2nd line) ICS309R-T While the information presented herein has been checked for both accuracy and reliability, Integrated Circuit Systems (ICS) assumes no responsibility for either its use or for the infringement of any patents or other rights of third parties, which would result from its use. No other circuits, patents, or licenses are implied. This product is intended for use in normal commercial applications ...

Related keywords