MK1714-02R IDT, Integrated Device Technology Inc, MK1714-02R Datasheet

no-image

MK1714-02R

Manufacturer Part Number
MK1714-02R
Description
IC CLK MULT SPRD SPECTRUM 20QSOP
Manufacturer
IDT, Integrated Device Technology Inc
Type
Clock Multiplierr
Datasheet

Specifications of MK1714-02R

Pll
Yes with Bypass
Input
Clock, Crystal
Output
CMOS
Number Of Circuits
1
Ratio - Input:output
1:2
Differential - Input:output
No/No
Frequency - Max
200MHz
Divider/multiplier
No/Yes
Voltage - Supply
3 V ~ 5.5 V
Operating Temperature
0°C ~ 70°C
Mounting Type
Surface Mount
Package / Case
20-QSOP
Frequency-max
200MHz
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Other names
800-2003-5
MK1714-02R

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
MK1714-02RI
Quantity:
150
SPREAD SPECTRUM MULTIPLIER CLOCK
Description
The MK1714-02 is a low cost, high performance clock
synthesizer with selectable multipliers and percentages of
spread designed to generate high frequency clocks with low
EMI. Using analog/digital Phase Locked Loop (PLL)
techniques, the device accepts an inexpensive,
fundamental mode, parallel resonant crystal or clock input
to produce a spread or dithered output. This reduces the
EMI amplitude peaks at the odd harmonics by several dB.
The OE pin puts both outputs into a high impedance state
for board level testing. The PD pin powers down the entire
chip and the outputs are held low.
Block Diagram
IDT™ SPREAD SPECTRUM MULTIPLIER CLOCK
Crystal or
Low E M I E nable
Clock
Input
S4:0
X 1
X 2
PD
5
O scillator
Crystal
X SE L
1
Features
G ND
V DD
Packaged in 20-pin tiny SSOP
Pb (lead) free package
Operating voltage of 3.3 V or 5 V
Multiplier modes of x1, x2, x3, x4, x5, and x6
Inexpensive 10 - 25 MHz crystal or clock input
OE pin tri-states the outputs for board testing
Power down pin stops the outputs low
Selectable frequency spread
Spread can be turned on or off
Advanced, low power CMOS process
Duty cycle of 40/60
Industrial temperature range available
M ultiplier and
2
4
P LL Clock
S pectrum
Circuitry
Spread
O E (both outputs)
Clock O ut
RE F
MK1714-02
DATASHEET
MK1714-02
REV K 051310

Related parts for MK1714-02R

MK1714-02R Summary of contents

Page 1

... SPREAD SPECTRUM MULTIPLIER CLOCK Description The MK1714- low cost, high performance clock synthesizer with selectable multipliers and percentages of spread designed to generate high frequency clocks with low EMI. Using analog/digital Phase Locked Loop (PLL) techniques, the device accepts an inexpensive, fundamental mode, parallel resonant crystal or clock input to produce a spread or dithered output ...

Page 2

... Note: When changing the input frequency, the LEE pin must be set low for minimum allow the PLL to lock to the new frequency. Alternatively, the PD pin may be set low while changing frequencies. IDT™ SPREAD SPECTRUM MULTIPLIER CLOCK 20 REF GND GND 12 LEE 11 XSEL Pin Description 2 SSCG MK1714-02 REV K 051310 ...

Page 3

... Both DC +0.25, -1.5 Both C ±0.75 Both D -0.5 Both DC +0.25, -2.25 3.3V D -0.25, -2.25 Both C ±0.75 Both DC +0.25, -1.25 Both C ±0.75 Both C ±0.75 Both C ±0.75 Both C ±0.75 Both DC +0.25, -1.5 Both DC +0.25, -1.25 Both D -1.5 Both C ±0.75 Both MK1714-02 REV K 051310 SSCG ...

Page 4

... An input signal should not be applied to ICLK until VDD is stable (within 10% of its final value). This requirement can be easily met by operating the MK1714-02 and the ICLK source from the same power supply. 2) LEE should not be enabled (taken high) until after the power supplies and input clock are stable. This requirement can be met by direct control of LEE by system logic ...

Page 5

... SPREAD SPECTRUM MULTIPLIER CLOCK Absolute Maximum Ratings Stresses above the ratings listed below can cause permanent damage to the MK1714-02. These ratings, which are standard values for IDT commercially rated parts, are stress ratings only. Functional operation of the device at these or any other conditions above those indicated in the operational sections of the specifications is not implied. ...

Page 6

... CLK at VDD/2 Symbol Conditions Still air JA 1 m/s air flow JA 3 m/s air flow SSCG Min. Typ. Max. Units 10 25 MHz 10 150 MHz 1 ±160 200 MHz 1 ppm Min. Typ. Max. Units 135 C/W 93 C/W 78 C/W 60 C/W MK1714-02 REV K 051310 ...

Page 7

... MK1714-01RLFTR MK1714-02RL MK1714-02RILF MK171402RIL MK1714-02RILFTR MK171402RIL "LF" suffix to the part number are the Pb-Free configuration and are RoHS compliant. While the information presented herein has been checked for both accuracy and reliability, Integrated Device Technology (IDT) assumes no responsibility for either its use or for the infringement of any patents or other rights of third parties, which would result from its use. No other circuits, patents, or licenses are implied ...

Page 8

... MK1714-02 SPREAD SPECTRUM MULTIPLIER CLOCK Innovate with IDT and accelerate your future networks. Contact: www.IDT.com For Sales 800-345-7015 408-284-8200 Fax: 408-284-2775 Corporate Headquarters Integrated Device Technology, Inc. www.idt.com © 2006 Integrated Device Technology, Inc. All rights reserved. Product specifications subject to change without notice. IDT and the IDT logo are trademarks of Integrated Device Technology, Inc ...

Related keywords