JBXFD1G08MCSDSMR Souriau Connection Technology, JBXFD1G08MCSDSMR Datasheet - Page 16

• Manufacturer Part Number: JBXFD1G08MCSDSMR
• Description: CONN PLUG 8POS STRAIGHT CRIMP
• Manufacturer: Souriau Connection Technology
• Series: JBXr

Specifications of JBXFD1G08MCSDSMR

• Connector Type: Plug, Male Pins
• Number Of Positions: 8
• Shell Size - Insert: 1
• Mounting Type: Free Hanging (In-Line)
• Termination: Crimp
• Fastening Type: Push-Pull
• Orientation: G
• Shell Material, Finish: Brass, Chrome over Nickel
• Features: Shielded
• Product Type: Connectors
• Shell Style: Plug
• Number Of Contacts: 8
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Ingress Protection: -
• Shell Size, Military: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: SOU1559

• Connector preparation
• Contacts wiring : crimp contacts
• Contacts wiring : solder contacts
• Connector assembly
1 - Position 2 half bushings
2 - Confirm that the key on the insulator
3 - Align the key slot on the collet with the keys on the half
4 - Insure the cable shield is still folded back and under the collet.
5 - Insert the insulator subassembly
6 - Make sure the window on the half bushing
7 - Apply thread lock to back nut
8 - Attach the back nut to the connector housing
9 - Use the correct size wrench, see page 19.
10 - Place the wrenches on the flats A and B. Tighten the back nut
11 - Install the protective boot if applicable.
Wiring and assembly
instructions :
STRAIGHT PLUG
window in the one half bushing.
bushings.
connector housing
Fixed solder contacts 0.5 mm and 0.7 mm
1 - Insert wire into solder cup and solder.
.
on either side of the insulator.
.
appears through the
&
is aligned with the key way on the connector housing
into the
JBX Series
2 - Insert contact into the insulator until the clip is fully seated and cannot be removed.
per the torque spec on page 19.
17
Removable solder contacts from 0.9 mm to 2 mm
1 - Insert wire into solder cup and solder.
Window
Flats B
1 - Select the proper collet. (see page 19)
2 - Slide the protective boot
3 - If a shielded cable is used fold the braid back
1 - Select the proper crimping tool and
2 - Adjust the crimping tool based on wire
3 - Crimp the contacts
the collet
(see pg. 17).
over the collet.
locator. (see page 48)
size “AWG”. (See wire size and crimp
tool settings on the back of the locator)
contact into the insulator until the clip is
fully seated and cannot be removed.
.
over the cable. Strip end of cable
then insert the
the backnut
Flats A
and