ATMEGA48A-PU Atmel, ATMEGA48A-PU Datasheet - Page 50
Manufacturer Part Number
IC MCU AVR 4K FLASH 28PDIP
Specifications of ATMEGA48A-PU
I²C, SPI, UART/USART
Brown-out Detect/Reset, POR, PWM, WDT
Number Of I /o
Program Memory Size
4KB (2K x 16)
Program Memory Type
256 x 8
512 x 8
Voltage - Supply (vcc/vdd)
1.8 V ~ 5.5 V
-40°C ~ 85°C
Package / Case
28-DIP (0.300", 7.62mm)
No. Of I/o's
Eeprom Memory Size
Ram Memory Size
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Watchdog System Reset
Internal Voltage Reference
Voltage Reference Enable Signals and Start-up Time
Figure 10-5. Brown-out Reset During Operation
When the Watchdog times out, it will generate a short reset pulse of one CK cycle duration. On
the falling edge of this pulse, the delay timer starts counting the Time-out period t
Figure 10-6. Watchdog System Reset During Operation
ATmega48A/48PA/88A/88PA/168A/168PA/328/328P features an internal bandgap reference.
This reference is used for Brown-out Detection, and it can be used as an input to the Analog
Comparator or the ADC.
The voltage reference has a start-up time that may influence the way it should be used. The
start-up time is given in
reference is not always turned on. The reference is on during the following situations:
1. When the BOD is enabled (by programming the BODLEVEL [2:0] Fuses).
2. When the bandgap reference is connected to the Analog Comparator (by setting the
3. When the ADC is enabled.
Thus, when the BOD is not enabled, after setting the ACBG bit or enabling the ADC, the user
must always allow the reference to start up before the output from the Analog Comparator or
ACBG bit in ACSR).
for details on operation of the Watchdog Timer.
”System and Reset Characteristics” on page
323. To save power, the
. Refer to