EZ80F92AZ020EG Zilog, EZ80F92AZ020EG Datasheet - Page 49

• Manufacturer Part Number: EZ80F92AZ020EG
• Description: IC ACCLAIM MCU 128KB 100LQFP
• Manufacturer: Zilog
• Series: eZ80® Acclaim!®r

Specifications of EZ80F92AZ020EG

• Core Processor: Z8
• Core Size: 8-Bit
• Speed: 20MHz
• Connectivity: I²C, IrDA, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, WDT
• Number Of I /o: 24
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 8K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 105°C
• Package / Case: 100-LQFP
• Processor Series: EZ80F92x
• Core: eZ80
• Data Bus Width: 8 bit
• Data Ram Size: 8 KB
• Interface Type: I2C, IrDA, SPI, UART
• Maximum Clock Frequency: 20 MHz
• Number Of Programmable I/os: 24
• Number Of Timers: 6
• Operating Supply Voltage: 3 V to 3.6 V
• Maximum Operating Temperature: + 105 C
• Mounting Style: SMD/SMT
• Development Tools By Supplier: eZ80F920200ZCOG
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Data Converters: -
• Lead Free Status / Rohs Status: Details
• Other names: 269-3871; EZ80F92AZ020EG

PS015313-0508
GPIO Interrupts
Each port pin can be used as an interrupt source. Interrupts can be either level- or edge-
triggered.
Level-Triggered Interrupts
When the port is configured for level-triggered interrupts, the corresponding port pin is
tristated. An interrupt request is generated when the level at the pin is the same as the level
stored in the Port x Data register. The port pin value is sampled by the system clock. The
input pin must be held at the selected interrupt level for a minimum of 2 consecutive clock
cycles to initiate an interrupt. The interrupt request remains active as long as this condition
is maintained at the external source.
For example, if PD3 is programmed for low-level interrupt and the pin is forced Low for 2
consecutive clock cycles, an interrupt request signal is generated from that port pin and
sent to the CPU. The interrupt request signal remains active until the external device
driving PD3 forces the pin High.
Edge-Triggered Interrupts
When the port is configured for edge-triggered interrupts, the corresponding port pin is
tristated. If the pin receives the correct edge from an external device, the port pin generates
System Clock
Data Bus
GPIO Register
Data (Output)
D
System Clock
Figure 5. GPIO Port Pin Block Diagram
Q
Mode 1
Mode 4
Mode 1
Mode 3
GPIO Register
Data (Input)
Q
D
Q
General-Purpose Input/Output
Product Specification
D
GND
eZ80F92/eZ80F93
V
DD
Port
Pin
42