MC908LJ24CPBE Freescale Semiconductor, MC908LJ24CPBE Datasheet - Page 153

• Manufacturer Part Number: MC908LJ24CPBE
• Description: IC MCU 24K FLASH 8MHZ SPI 64LQFP
• Manufacturer: Freescale Semiconductor
• Series: HC08r

Specifications of MC908LJ24CPBE

• Core Processor: HC08
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: I²C, IRSCI, SPI
• Peripherals: LCD, LVD, POR, PWM
• Number Of I /o: 40
• Program Memory Size: 24KB (24K x 8)
• Program Memory Type: FLASH
• Ram Size: 768 x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 5.5 V
• Data Converters: A/D 6x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-LQFP
• Processor Series: HC08LJ
• Core: HC08
• Data Bus Width: 8 bit
• Data Ram Size: 768 B
• Interface Type: SCI/SPI
• Maximum Clock Frequency: 8 MHz
• Number Of Programmable I/os: 48
• Number Of Timers: 4
• Operating Supply Voltage: 3.3 V, 5 V
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Development Tools By Supplier: FSICEBASE, M68EML08LJLKE, ZK-HC08LX-A, M68CBL05CE
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 6-ch x 10-bit
• Controller Family/series: HC08
• No. Of I/o's: 40
• Ram Memory Size: 768Byte
• Cpu Speed: 8MHz
• No. Of Timers: 2
• Embedded Interface Type: I2C, SCI, SPI
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

9.6.1.2 SWI Instruction
9.6.1.3 Interrupt Status Registers
9.6.1.4 Interrupt Status Register 1
MC68HC908LJ24/LK24 — Rev. 2.1
Freescale Semiconductor
NOTE:
Address:
The SWI instruction is a non-maskable instruction that causes an
interrupt regardless of the state of the interrupt mask (I bit) in the
condition code register.
A software interrupt pushes PC onto the stack. A software interrupt does
not push PC – 1, as a hardware interrupt does.
The flags in the interrupt status registers identify maskable interrupt
sources.
status register flags that they set. The interrupt status registers can be
useful for debugging.
IF6–IF1 — Interrupt Flags 6–1
Bit 0 and Bit 1 — Always read 0
Reset:
Read:
Write:
These flags indicate the presence of interrupt requests from the
sources shown in
1 = Interrupt request present
0 = No interrupt request present
$FE04
Bit 7
IF6
Table 9-3
R
R
0
System Integration Module (SIM)
Figure 9-12. Interrupt Status Register 1 (INT1)
= Reserved
IF5
R
6
0
summarizes the interrupt sources and the interrupt
Table
IF4
R
5
0
9-3.
IF3
R
4
0
IF2
R
3
0
System Integration Module (SIM)
IF1
R
2
0
Exception Control
R
1
0
0
Data Sheet
Bit 0
R
0
0
153