R5F21334CNFP#U0 Renesas Electronics America, R5F21334CNFP#U0 Datasheet - Page 239

• Manufacturer Part Number: R5F21334CNFP#U0
• Description: MCU 1KB FLASH 16K ROM 32-LQFP
• Manufacturer: Renesas Electronics America
• Series: R8C/3x/33Cr

Specifications of R5F21334CNFP#U0

• Core Processor: R8C
• Core Size: 16/32-Bit
• Speed: 20MHz
• Connectivity: I²C, LIN, SIO, SSU, UART/USART
• Peripherals: POR, PWM, Voltage Detect, WDT
• Number Of I /o: 27
• Program Memory Size: 16KB (16K x 8)
• Program Memory Type: FLASH
• Ram Size: 1.5K x 8
• Voltage - Supply (vcc/vdd): 1.8 V ~ 5.5 V
• Data Converters: A/D 12x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 85°C
• Package / Case: 32-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

R8C/33C Group
REJ09B0570-0100 Rev.1.00 Dec. 14, 2009
Page 209 of 589
17.6
Table 17.5
Count sources
Count operations
Count start condition
Count stop conditions
Interrupt request
generation timing
TRAIO pin function
TRAO pin function
Read from timer
Write to timer
Selectable functions
In pulse width measurement mode, the pulse width of an external signal input to the TRAIO pin is measured
(refer to Table 17.5 Pulse Width Measurement Mode Specifications).
Figure 17.3 shows an Operating Example of Pulse Width Measurement Mode.
Pulse Width Measurement Mode
Item
Pulse Width Measurement Mode Specifications
f1, f2, f8, fOCO, fC32, fC
• Decrement
• Continuously counts the selected signal only when measurement pulse is “H”
• When the timer underflows, the contents of the reload register are reloaded
• 0 (count stops) is written to the TSTART bit in the TRACR register.
• 1 (count forcibly stops) is written to the TSTOP bit in the TRACR register.
• When timer RA underflows [timer RA interrupt].
• Rising or falling of the TRAIO input (end of measurement period) [timer RA
Measured pulse input
• When registers TRAPRE and TRA are written while the count is stopped,
• When registers TRAPRE and TRA are written during the count, values are
• Measurement level setting
• Measured pulse input pin select function
• Digital filter function
1 (count starts) is written to the TSTART bit in the TRACR register.
Programmable I/O port
The count value can be read by reading registers TRA and TRAPRE.
level, or conversely only “L” level.
and the count is continued.
interrupt]
values are written to both the reload register and counter.
written to the reload register and counter (refer to 17.3.2 Timer Write
Control during Count Operation ).
The “H” level or “L” level period is selected by the TEDGSEL bit in the
TRAIOC register.
P1_5 or P1_7 is selected by bits TRAIOSEL0 to TRAIOSEL1 in the TRASR
register.
Whether enabling or disabling the digital filter and the sampling frequency is
selected by bits TIPF0 and TIPF1 in the TRAIOC register.
Specification
17. Timer RA