MC68HC711E9CFNE3 Freescale Semiconductor, MC68HC711E9CFNE3 Datasheet - Page 239

• Manufacturer Part Number: MC68HC711E9CFNE3
• Description: IC MCU 3MHZ 12K OPT 52-PLCC
• Manufacturer: Freescale Semiconductor
• Series: HC11r

Specifications of MC68HC711E9CFNE3

• Core Processor: HC11
• Core Size: 8-Bit
• Speed: 3MHz
• Connectivity: SCI, SPI
• Peripherals: POR, WDT
• Number Of I /o: 38
• Program Memory Size: 12KB (12K x 8)
• Program Memory Type: OTP
• Eeprom Size: 512 x 8
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 52-PLCC
• Processor Series: HC711E
• Core: HC11
• Data Bus Width: 8 bit
• Data Ram Size: 512 B
• Interface Type: SCI, SPI
• Maximum Clock Frequency: 3 MHz
• Number Of Programmable I/os: 38
• Number Of Timers: 8
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 8 bit
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Step 6
After the programming operation is complete, PCbug11 will display this message
Total bytes loaded: $xxxx
Total bytes programmed: $yyyy
Substitute the name of your program into the command above. Use a full path name if your program is
not located in the same directory as PCbug11.
If the verify operation fails, a list of addresses which did not program correctly is displayed. Should this
occur, you probably need to erase your part more completely. To do so, allow the MC68HC711E9 to sit
for at least 45 minutes under an ultraviolet light source. Attempt the programming operation again. If you
have purchased devices in plastic packages (one-time programmable parts), you will need to try again
with a new, unprogrammed device.
Freescale Semiconductor
•
•
•
•
You should now remove the programming voltage from P4 connector pin 18, the XIRQ* pin.
Each ORG directive in your assembly language source will cause a pair of these lines to be
generated. For this operation, $yyyy will be incremented by the size of each block of code
programmed into the EPROM of the MC68HC711E9.
PCbug11 will display the above message whether or not the programming operation was
successful. As a precaution, you should have PCbug11 verify your code.
At the PCbug11 command prompt type: VERF C:\MYPROG\ISHERE.S19
Programming MC68HC711E9 Devices with PCbug11 and the M68HC11EVBU, Rev. 0.1
Programming Procedure
239