DF2161BVTE10 Renesas Electronics America, DF2161BVTE10 Datasheet - Page 174

• Manufacturer Part Number: DF2161BVTE10
• Description: MCU 3V 128K 144-TQFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2100r

Specifications of DF2161BVTE10

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 10MHz
• Connectivity: Host Interface (LPC), I²C, IrDA, SCI, X-Bus
• Peripherals: PWM, WDT
• Number Of I /o: 114
• Program Memory Size: 128KB (128K x 8)
• Program Memory Type: FLASH
• Ram Size: 4K x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 3.6 V
• Data Converters: A/D 8x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 75°C
• Package / Case: 144-TQFP, 144-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Other names: HD64F2161BVTE10; HD64F2161BVTE10

Section 5 Interrupt Controller
5.8
5.8.1
When an interrupt enable bit is cleared to 0 to disable interrupt requests, the disabling becomes
effective after execution of the instruction. When an interrupt enable bit is cleared to 0 by an
instruction such as BCLR or MOV, and if an interrupt is generated during execution of the
instruction, the interrupt concerned will still be enabled on completion of the instruction, so
interrupt exception handling for that interrupt will be executed on completion of the instruction.
However, if there is an interrupt request of higher priority than that interrupt, interrupt exception
handling will be executed for the higher-priority interrupt, and the lower-priority interrupt will be
ignored. The same rule is also applied when an interrupt source flag is cleared to 0. Figure 5.11
shows an example in which the CMIEA bit in the TMR's TCR register is cleared to 0.
The above conflict will not occur if an enable bit or interrupt source flag is cleared to 0 while the
interrupt is masked.
Rev. 3.00 Mar 21, 2006 page 118 of 788
REJ09B0300-0300
Internal
address bus
Internal
write signal
CMIEA
CMFA
CMIA
interrupt signal
Usage Notes
Conflict between Interrupt Generation and Disabling
Figure 5.11 Conflict between Interrupt Generation and Disabling
TCR write cycle
TCR address
by CPU
CMIA exception handling