DF2378RVFQ34WV Renesas Electronics America, DF2378RVFQ34WV Datasheet - Page 412

• Manufacturer Part Number: DF2378RVFQ34WV
• Description: MCU 3V 512K I-TEMP PB-FREE 144-L
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2300r

Specifications of DF2378RVFQ34WV

• Core Processor: H8S/2000
• Core Size: 16-Bit
• Speed: 34MHz
• Connectivity: I²C, IrDA, SCI, SmartCard
• Peripherals: DMA, POR, PWM, WDT
• Number Of I /o: 97
• Program Memory Size: 512KB (512K x 8)
• Program Memory Type: FLASH
• Ram Size: 32K x 8
• Voltage - Supply (vcc/vdd): 3 V ~ 3.6 V
• Data Converters: A/D 16x10b; D/A 6x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 144-LQFP
• For Use With: YLCDRSK2378 - KIT DEV EVAL H8S/2378 LCDYR0K42378FC000BA - KIT EVAL FOR H8S/2378HS0005KCU11H - EMULATOR E10A-USB H8S(X),SH2(A)EDK2378 - DEV EVAL KIT FOR H8S/2378
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -

Section 7 DMA Controller (DMAC)
DREQ pin sampling is performed every cycle, with the rising edge of the next φ cycle after the
end of the DMABCR write cycle for setting the transfer enabled state as the starting point.
When the DREQ pin low level is sampled while acceptance by means of the DREQ pin is
possible, the request is held in the DMAC. Then, when activation is initiated in the DMAC, the
request is cleared, and DREQ pin high level sampling for edge detection is started. If DREQ pin
high level sampling has been completed by the time the DMA single cycle ends, acceptance
resumes after the end of the single cycle, DREQ pin low level sampling is performed again, and
this operation is repeated until the transfer ends.
Rev.7.00 Mar. 18, 2009 page 344 of 1136
REJ09B0109-0700
Figure 7.30 Example of DREQ Pin Falling Edge Activated Single Address Mode Transfer
Address bus
[1]
[2] [5] The request is cleared at the next bus break, and activation is started in the DMAC.
[3] [6] Start of DMA cycle; DREQ pin high level sampling on the rising edge of φ starts.
[4] [7] When the DREQ pin high level has been sampled, acceptance is resumed after the single
Note: In write data buffer mode, bus breaks from [2] to [7] may be hidden, and not visible.
DMA control
Channel
DREQ
DACK
Acceptance after transfer enabling; the DREQ pin low level is sampled on the rising edge of φ,
and the request is held.
cycle is completed. (As in [1], the DREQ pin low level is sampled on the rising edge of φ, and
the request is held.)
φ
Idle
[1]
Request
Bus release
Minimum of
2 cycles
[2]
[3]
Single
Request clear
Transfer source/
DMA single
period
destination
Acceptance resumes
Idle
[4]
Request
Bus release
Minimum of
2 cycles
[5]
[6]
Single
DMA single
Request clear
Transfer source/
destination
period
Acceptance resumes
Idle
[7]
Bus release