HD64F2638F20J Renesas Electronics America, HD64F2638F20J Datasheet - Page 547

• Manufacturer Part Number: HD64F2638F20J
• Description: IC H8S MCU FLASH 256K 128-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of HD64F2638F20J

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: CAN, SCI, SmartCard
• Peripherals: Motor Control PWM, POR, PWM, WDT
• Number Of I /o: 72
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 12x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 128-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

H8S/2639, H8S/2638, H8S/2636,
H8S/2630, H8S/2635 Group
• Serial data transmission (clocked synchronous mode)
REJ09B0103-0800 Rev. 8.00
May 28, 2010
Figure 13-16 shows a sample flowchart for serial transmission.
The following procedure should be used for serial data transmission.
Write transmit data to TDR and
clear TDRE flag in SSR to 0
Read TDRE flag in SSR
Read TEND flag in SSR
Clear TE bit in SCR to 0
All data transmitted?
Start transmission
Initialization
TDRE = 1
TEND = 1
<End>
Figure 13-16 Sample Serial Transmission Flowchart
Yes
Yes
Yes
No
No
No
[3]
[2]
[1]
[1] SCI initialization:
[2] SCI status check and transmit data
[3] Serial transmission continuation
The TxD pin is automatically
designated as the transmit data output
pin.
write:
Read SSR and check that the TDRE
flag is set to 1, then write transmit data
to TDR and clear the TDRE flag to 0.
procedure:
To continue serial transmission, be
sure to read 1 from the TDRE flag to
confirm that writing is possible, then
write data to TDR, and then clear the
TDRE flag to 0.
Checking and clearing of the TDRE
flag is automatic when the DTC is
activated by a transmit data empty
interrupt (TXI) request and data is
written to TDR.
Section 13 Serial Communication Interface (SCI)
Page 497 of 1458