HD64F2638F20J Renesas Electronics America, HD64F2638F20J Datasheet - Page 708

IC H8S MCU FLASH 256K 128-QFP

HD64F2638F20J

Manufacturer Part Number
HD64F2638F20J
Description
IC H8S MCU FLASH 256K 128-QFP
Manufacturer
Renesas Electronics America
Series
H8® H8S/2600r
Datasheets

Specifications of HD64F2638F20J

Core Processor
H8S/2600
Core Size
16-Bit
Speed
20MHz
Connectivity
CAN, SCI, SmartCard
Peripherals
Motor Control PWM, POR, PWM, WDT
Number Of I /o
72
Program Memory Size
256KB (256K x 8)
Program Memory Type
FLASH
Ram Size
16K x 8
Voltage - Supply (vcc/vdd)
4.5 V ~ 5.5 V
Data Converters
A/D 12x10b; D/A 2x8b
Oscillator Type
Internal
Operating Temperature
-40°C ~ 85°C
Package / Case
128-QFP
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Eeprom Size
-

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
HD64F2638F20J
Manufacturer:
PENESAS
Quantity:
252
Section 16 Controller Area Network (HCAN)
• Receive-only mailbox (mailbox 0)
Mailbox (Message Control/Data (MCx[x], MDx[x]) Initial Settings: After power is supplied,
all registers and RAM (message control/data, control registers, status registers, etc.) are initialized.
Message control/data (MCx[x], MDx[x]) only are in RAM, and so their values are undefined.
Initial values must therefore be set in all the mailboxes (by writing 0s or 1s).
Setting the Message Transmission Method: Either of the following message transmission
methods can be selected with the message transmission method bit (MCR2) in the master control
register (MCR):
a. Transmission order determined by message identifier priority
b. Transmission order determined by mailbox number priority
When a is selected, if a number of messages are designated as waiting for transmission (TXPR =
1), the message with the highest priority set in the message identifier (MCx[5] to MCx[8]) is
stored in the transmit buffer. CAN bus arbitration is then carried out for the message in the
transmit buffer, and message transmission is performed when the transmission right is acquired.
When the TXPR bit is set, internal arbitration is performed again, and the highest-priority message
is found and stored in the transmit buffer.
When b is selected, if a number of messages are designated as waiting for transmission (TXPR =
1), messages are stored in the transmit buffer in low-to-high mailbox order (priority order:
mailbox 1 > mailbox 15). CAN bus arbitration is then carried out for the messages in the transmit
buffer, and message transmission is performed when the bus is acquired.
Page 658 of 1458
Setting a bit to 1 in the mailbox configuration register (MBCR) designates the corresponding
mailbox for reception use. When setting mailboxes for reception, to improve message
transmission efficiency, high-priority messages should be set in low-to-high mailbox order
(priority order: mailbox 1 > mailbox 15).
No setting is necessary, as this mailbox is always used for reception.
H8S/2639, H8S/2638, H8S/2636,
REJ09B0103-0800 Rev. 8.00
H8S/2630, H8S/2635 Group
May 28, 2010

Related parts for HD64F2638F20J