HD64F2638F20J Renesas Electronics America, HD64F2638F20J Datasheet - Page 728

• Manufacturer Part Number: HD64F2638F20J
• Description: IC H8S MCU FLASH 256K 128-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of HD64F2638F20J

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: CAN, SCI, SmartCard
• Peripherals: Motor Control PWM, POR, PWM, WDT
• Number Of I /o: 72
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 12x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 128-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 16 Controller Area Network (HCAN)
(7) Register retention during standby
All HCAN registers are initialized in hardware standby mode and software standby mode.
(8) Usage of bit manipulation instructions
The HCAN status flags are cleared by writing 1, so do not use a bit manipulation instruction to
clear a flag.
When clearing a flag, use the MOV instruction to write 1 to only the bit that is to be cleared.
(9) HCAN TXCR Operation
Page 678 of 1458
1. When the transmit wait cancel register (TXCR) is used to cancel transmission of the
2. When the bus-off state is entered while any mailbox is waiting for transmission with TXPR
⎯ The HRxD pin is tied to "1" because of a CAN bus error, etc.
⎯ There is one or more mailboxes waiting for transmission or transmitting.
⎯ Ongoing message transmission from a mailbox is canceled by TXCR.
⎯ Do not cancel transmission by TXCR. Transmission will be completed after the CAN
⎯ To cancel transmission, write 1 to the corresponding bit in TXCR repeatedly until the
message in a mailbox waiting for transmission, the corresponding bit in TXCR and the
transmit wait register (TXPR) may not be cleared even after the transmission is canceled.
This occurs when the following conditions are all satisfied.
[Conditions]
If this occurs, the transmission is canceled but TXPR and TXCR continue to indicate a
wrong status telling that a message is being cancelled. As a result, transmission cannot be
restarted even after the HRxD pin is released from the tied state and the CAN bus has
recovered. If there are two or more messages for transmission, a message which is not
being transmitted is canceled and a message being transmitted retains its state.
To avoid this, take either of the following countermeasures.
[Countermeasures]
set, transmission cannot be canceled even if TXCR is set because the internal state machine
does not operate during the bus-off state. Because of this, on recovery from the bus-off
state, one message will be transmitted or the message will be canceled with a transmission
error. For message clearing on recovery from the bus-off state, take the following
countermeasure.
bus has recovered, then TXPR is cleared and the HCAN operates normally.
bit becomes 0. TXPR and TXCR are cleared, and the HCAN operates normally.
H8S/2639, H8S/2638, H8S/2636,
REJ09B0103-0800 Rev. 8.00
H8S/2630, H8S/2635 Group
May 28, 2010