HD64F2638F20J Renesas Electronics America, HD64F2638F20J Datasheet - Page 818

• Manufacturer Part Number: HD64F2638F20J
• Description: IC H8S MCU FLASH 256K 128-QFP
• Manufacturer: Renesas Electronics America
• Series: H8® H8S/2600r

Specifications of HD64F2638F20J

• Core Processor: H8S/2600
• Core Size: 16-Bit
• Speed: 20MHz
• Connectivity: CAN, SCI, SmartCard
• Peripherals: Motor Control PWM, POR, PWM, WDT
• Number Of I /o: 72
• Program Memory Size: 256KB (256K x 8)
• Program Memory Type: FLASH
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 12x10b; D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 128-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -

Section 21A ROM
(H8S/2636 Group)
On-Chip RAM Area Divisions in Boot Mode: In boot mode, the RAM area is divided into an
area used by the boot program and an area to which the programming control program is
transferred via the SCI, as shown in figure 21A-9. The boot program area cannot be used until the
execution state in boot mode switches to the programming control program transferred from the
host.
Notes on Use of Boot Mode:
• When the chip comes out of reset in boot mode, it measures the low-level period of the input at
• In boot mode, if any data has been programmed into the flash memory (if all data is not 1), all
• Interrupts cannot be used while the flash memory is being programmed or erased.
• The RxD1 and TxD1 pins should be pulled up on the board.
Page 768 of 1458
Note: The boot program area cannot be used until a transition is made to the execution state for
the SCI’s RxD1 pin. The reset should end with RxD1 high. After the reset ends, it takes
approximately 100 states before the chip is ready to measure the low-level period of the RxD1
pin.
flash memory blocks are erased. Boot mode is for use when user program mode is unavailable,
such as the first time on-board programming is performed, or if the program activated in user
program mode is accidentally erased.
the programming control program transferred to RAM. Note also that the boot program
remains in this area of the on-chip RAM even after control branches to the programming
control program.
Figure 21A-9 RAM Areas in Boot Mode
H'FFE000
H'FFE7FF
H'FFE800
H'FFEFBF
control program area
Boot program area
Programming
(1.9 kbytes)
(2 kbytes)
H8S/2639, H8S/2638, H8S/2636,
REJ09B0103-0800 Rev. 8.00
H8S/2630, H8S/2635 Group
May 28, 2010