ATMEGA103L-4AI Atmel, ATMEGA103L-4AI Datasheet - Page 59

IC MCU 128K 4MHZ A/D LV 64TQFP

ATMEGA103L-4AI

Manufacturer Part Number
ATMEGA103L-4AI
Description
IC MCU 128K 4MHZ A/D LV 64TQFP
Manufacturer
Atmel
Series
AVR® ATmegar

Specifications of ATMEGA103L-4AI

Core Processor
AVR
Core Size
8-Bit
Speed
4MHz
Connectivity
SPI, UART/USART
Peripherals
POR, PWM, WDT
Number Of I /o
32
Program Memory Size
128KB (64K x 16)
Program Memory Type
FLASH
Eeprom Size
4K x 8
Ram Size
4K x 8
Voltage - Supply (vcc/vdd)
2.7 V ~ 3.6 V
Data Converters
A/D 8x10b
Oscillator Type
Internal
Operating Temperature
-40°C ~ 85°C
Package / Case
64-TQFP, 64-VQFP
For Use With
ATSTK501 - ADAPTER KIT FOR 64PIN AVR MCU
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Prevent EEPROM
Corruption
0945I–AVR–02/07
During periods of low V
age is too low for the CPU and the EEPROM to operate properly. These issues are the
same as for board-level systems using the EEPROM and the same design solutions
should be applied.
An EEPROM Data corruption can be caused by two situations when the voltage is too
low. First, a regular write sequence to the EEPROM requires a minimum voltage to
operate correctly. Second, the CPU itself can execute instructions incorrectly if the sup-
ply voltage for executing instructions is too low.
EEPROM Data corruption can easily be avoided by following these design recommen-
dations (one is sufficient):
1. Keep the AVR RESET active (low) during periods of insufficient power supply
2. Keep the AVR core in Power-down sleep mode during periods of low V
3. Store constants in Flash memory if the ability to change memory contents from
voltage. This is best done by an external low V
referred to as a Brown-out Detector (BOD). Please refer to application note “AVR
180” for design considerations regarding Power-on Reset and low-voltage
detection.
will prevent the CPU from attempting to decode and execute instructions, effec-
tively protecting the EEPROM Registers from unintentional writes.
software is not required. Flash memory cannot be updated by the CPU and will
not be subject to corruption.
CC
, the EEPROM Data can be corrupted because the supply volt-
CC
Reset Protection circuit, often
ATmega103(L)
CC
. This
59

Related parts for ATMEGA103L-4AI