MC68HC711D3CFN2 Freescale Semiconductor, MC68HC711D3CFN2 Datasheet - Page 15

• Manufacturer Part Number: MC68HC711D3CFN2
• Description: IC MCU 2MHZ 4K OTP 44-PLCC
• Manufacturer: Freescale Semiconductor
• Series: HC11r

Specifications of MC68HC711D3CFN2

• Core Processor: HC11
• Core Size: 8-Bit
• Speed: 2MHz
• Connectivity: SCI, SPI
• Peripherals: POR, WDT
• Number Of I /o: 26
• Program Memory Size: 4KB (4K x 8)
• Program Memory Type: OTP
• Ram Size: 192 x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 44-PLCC
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Eeprom Size: -
• Data Converters: -

2.3 Crystal Driver and External Clock Input (XTAL, EXTAL)
TECHNICAL DATA
constant can cause the device to misinterpret the type of reset that occurred. Refer to
SECTION 5 RESETS AND INTERRUPTS for further information.
Figure 2-3 illustrates a reset circuit that uses an external switch. Use a low voltage
interrupt circuit, however, to prevent corruption of RAM.
These two pins provide the interface for either a crystal or a CMOS compatible clock
to control the internal clock generator circuitry. The frequency applied to these pins is
four times higher than the desired E-clock rate.
The XTAL pin is normally left unterminated when an external CMOS compatible clock
input is connected to the EXTAL pin. However, a 10 k
nected from XTAL to ground can be used to reduce RFI noise emission. The XTAL
output is normally intended to drive only a crystal. The XTAL output can be buffered
with a high impedance buffer, or it can be used to drive the EXTAL input of another
M68HC11.
In all cases, use caution around the oscillator pins. Load capacitances shown in the
oscillator circuits include all stray layout capacitances. Refer to Figure 2-4, Figure 2-
5, and Figure 2-6.
*
THIS VALUE INCLUDES ALL STRAY CAPACITANCES.
MC34(0/1)64
MCU
Figure 2-4 Common Crystal Connections
GND
EXTAL
V DD
IN
Freescale Semiconductor, Inc.
XTAL
RESET
2
3
For More Information On This Product,
Figure 2-3 External Reset Circuit
1
Go to: www.freescale.com
V DD
PIN DESCRIPTIONS
4.7 k
10 M
TO RESET
OF M68HC11
CRYSTAL
4 x E
25 pF
25 pF
to 100 k
EXT RESET CIRCUIT
*
*
load resistor con-
COMMON XTAL CONN
2-3